01 November 2023 0 5K Report

Hello everyone,

I am planning to transfect my cells with ADCy2 and conduct an Immunocytochemistry assay afterward. I am currently considering the U373 MG (ATCC) cell line and the U87 cell line. I would like to know which one would be more suitable for this assay.

I appreciate your assistance.

Thank you.

More Mahla Vaghari's questions See All
Asked a question in 3D-QSAR?

Hi good day Can you suggest a solution to build COMFA and COMSIA models with better Q2? Thank you in advance.

28 October 2023 4,208 5 View

How to interpret results of tof-mass chromatogram?

Hi, I extracted lipopeptide of Pseudomonas fluorescens and TOF-MASS done on it. Can anyone help me to interpret tof- mass chromatogram, ? thanks a lot

07 September 2022 5,492 1 View

In the SPF calculation formula, how do we calculate the constant values of spectral intensity for the rest of the wavelengths?

In the SPF calculation formula, fixed values of spectral intensities are specified for only seven wavelengths. On the other hand, because the formula is continuous, it is not possible to put only...

28 March 2022 3,538 0 View

Is there anybody who know about the acidic extraction protocol for microbial metabolite?

I need the generally protocol🤷‍♀️

09 November 2021 1,328 3 View

How to interpret Rarefaction curves?

Hello! I am trying to interpret this rarefaction curve as I am writing an article regarding the biodiversity of endophytic bactria in grapevine and drew figure by PAST program, but I can't...

26 July 2021 3,288 2 View

Natural frequency extraction with ABAQUS?

I have modeled the RC beam with simply supported BC and I have got the frequency value for the case of the beam, but I have 150 modes for each analysis and I have to see them one by one to find...

05 January 2021 8,993 3 View

How to plot isopleth diagram with ThermoCalc?

Can we get isopleth diagram like attached diagram directly from Thermo-Calc software or we need another software?

21 April 2020 6,171 2 View

FCC_A1 and FCC_L12 in HEAs?

If in the Thermo-Calc analysis of a system of elements in ABCDE quinary alloy we have FCC _A1 and FCC_L12 which one is better mechanical properties?

05 March 2020 8,640 4 View

Need Information about a Thermo-Calc simulation of AlMgMnMoZn ?

I’m trying to choose an alloy composition and I need to simulate AlMgMnMoZn with Thermo-Calc software and I don’t access this software. My simulation with Jmatpro software attached here. Can you...

19 December 2019 2,905 3 View

How to fix mixlogit error "no within-group variance"?

I attached a picture of how my data for conjoint analysis looks. I have a choice variable that people chose among choice card A, B or an opt-out option based on three attributes (Local sourcing,...

27 January 2019 2,633 0 View

Similar questions and discussions
Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Does Anyone have expertise in in vitro transcription and RNA pull down assay?

I am currently working on LncRNA; to know the lncRNA-protein interactions I want to do RNA pull down assay, so I need to design primers with T7 promoter. I need assistance in this regard.

07 August 2024 6,622 1 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

How to improve plaques in Double Layer Agar Assay?

Hi all! My thesis groupmates and I are working on purifying an E. coli bacteriophage. The phage was handed down to us by the previous thesis group, but they only managed to purify it to about...

06 August 2024 5,801 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

How to Add Missing Water Molecules in Protein-Membrane Simulations?

I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...

04 August 2024 1,200 2 View

Does long-term culture of murine Monocytes result in macrophage differentiation?

Hi, I am isolating monocytes from the bone marrow using the Mouse Monocyte EasySep kit. I want to treat these cells and monitor expression of specific markers over the course of 10 days. I will...

04 August 2024 7,282 2 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close