Resistivity of PVD TiNx thin films vs. N2 flow?

In the PVD of TiN thin films (~100A), I've found the resistivity of the TiN films dropped from ~100 to 60um*cm with N2 flow increasing up to the metallic mode ending point; then the resistivity...

21 February 2021 1,864 2 View

Do you have some articles to recommend about comparative experimental study about gas and water flooding with oil reservoirs?

I would like to know in the oil extraction, which is more efficient: gas flooding or water flooding? Will water flooding be more efficient in hydrophilic reservoirs with capillary...

29 December 2020 3,471 3 View

What does this PZC data mean?

I measured different kinds of catalysts which were dispersed in DI water.I firstly added certain amount of HCl and then used NaOH to titrate and measure the pH value. What does this result mean?

27 December 2020 5,728 4 View

How to inhibit the ion conversion between Mn4 + and MN2 +?

Dear scientists, I have a question to ask you, it is known that Mn4+ is beneficial to the soil, but part of Mn4+ in the soil is easy to be converted to MN2 +, is there any way to inhibit its ion...

21 November 2020 1,200 5 View

Failure in using Gene Pulser Xcell (Biorad) ?

02 October 2020 8,642 1 View

Hi everyone, how can we remove the snow-covered areas in global scale?

We obtained the global results using remote sensing reanalysis dataset. But the snow-coverd areas should be removed (like the blank area in the picture below, sources: Purdy et al., 2016). Does...

20 September 2020 3,463 5 View

How to set the fluent simulation species transport density item?

I use fluent to simulate species transport. The medium is sulfur hexafluoride and air. There is a density item under the mixture, and there is also under the fluid. Is there any difference between...

29 July 2020 7,414 4 View

How to detect brown pigments generated in red wine aging process ?

During aging or storage, the concentration of monomeric anthocyanins decreases rapidly, while low level of polymeric anthocyanins generates, and the color of wine turns brick-red gradually. In...

17 July 2020 6,032 4 View

How to calculate mode overlap ratio in Comsol ?

As is shown in attachment, there is hybrid plasmonic waveguide (HPW) and dielectric waveguide (DW), I want know how to calculate mode overlap ratio to evaluated the mode distribution similarity...

14 July 2020 2,275 3 View

Is there any organic solvent for MnCO3?

Since that my experiment could not be proceeded in aqueous. Anyone who know is there any organic solvent for MnCO3, the concentration could be as low as several mg/mL. Thanks

02 July 2020 9,654 19 View

Logistical regression using SPSS for a dichotomous dependent variable, with an independent variable of 1, 2, 5 and 10 seconds?

I have an experiment with 28 participants The independent variable is the times 1, 2, 5, and 10 used as the cross hairs during a task These 4 times were tested using 4 different blocks, each...

03 March 2021 9,692 2 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

How to calculate average trend in maximum annual NDVI from MODIS?

I am wanting to calculate the average trend in maximum annual NDVI in Iceland from 2010-2020 using MODIS MYD13Q1 V6. How would I do this? I have currently inserted the NDVI bands from the MODIS...

02 March 2021 752 2 View

How to perform statistical analysis of coefficients extracted from transform techniques?

I am studying the potential of DCT and FFT coefficients extracted from a signal to classify the different objects that emit the signal. I applied the Shapiro-Wilk to confirm that data was not...

01 March 2021 8,079 2 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

Can polymer concentrations be calculated based on the number average molecular weight?

Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...

28 February 2021 7,882 2 View

How can I publish a manuscript in free or low cost journal with good H-Index?

Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...

28 February 2021 7,800 6 View

Can anyone provide the Support vector regression code structure of LIBSVM MATLAB or python ?

Please, if Gaussian Parameter optimization is possible in this code structure

28 February 2021 278 3 View

How could I take into consideration the weights of observation in a system of seemingly unrelated regressions (SUR) in rstudio?

I build a model of 4 regression equations (probit and OLS) in R studio. I need to take the weights of observations into consideration. While it is simple to do so for every regression equation,...

27 February 2021 1,233 1 View

The Shannon's index is inversely proportional to Simpson's index (1-D)?

I'm having a problem with my bloxplot with Shannon's and Simpson's indexs. The value of Shannon for my Community 1 indicating higher diversity (in relation of the Community 2), but have lower...

26 February 2021 3,033 9 View