Dear all, I need some help from u. how much hp submersible pump is needed for a 400 feet 7" bore (The bore is of 800 feet depth) , and need a discharge 2.5" out from the motor. (no idea on pressure, but the purpose is in industry)
power transmission engineering,tie line power
10 November 2015 1,159 2 View
other than energy meter..
09 October 2015 3,291 4 View
Vertebrates and invertebrates (e.g., arthropods: insects, crustaceans, etc.) have two different neuro-muscular systems given their differential construction: the former have an endoskeleton and...
07 August 2024 648 0 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...
21 July 2024 1,680 2 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
I'd like to know if anyone has got experience in intracerebroventricular (ICV) AAV inj. I am looking for a concomitant spread of the AAV including but not limited to the motor cortex and the...
12 July 2024 781 0 View
Hello everyone. I am working on my LV concentration porject, I use 500Kda hollowfiber to do it. The HCP and BSA removal rate is nearly 80%, but last time, I failed to run it. The HCP hasn't been...
11 July 2024 5,380 0 View
I am using a polygon mirror scanner that have 6 facets and the dc brushless motor speed was given 10,000 RPM. Now I want to know how to calculate the polygon speed if I change the power supply...
11 July 2024 5,942 1 View
What will be the pressure in Iron Iron-Carbide diagram? It is at atmospheric pressure?
05 July 2024 1,891 0 View
I need to put an extra motor on the knee to do part of my project. The process of doing it is needed in the use of other software and sub-programs.
03 July 2024 6,038 0 View