I am sorry; I cannot help you. I do not have any working experience in this field of research. With best wishes- D.K.Pal

This error could be a result of two possibilities - the access database is inaccessible by swat routine or the table in the database has the table not formatted correctly. I recommend, opening SWAT2012.mdb and check the table listed as "resrng," especially the values set in there. Sometimes it could be that the database file property is set to be read/execution protected. Check these aspects and hope this helps. 

Try to contact the following two persons:

Swiss Federal Institute of Aquatic Science and Technology - Eawag

Siam -System Analysis, Integrated Assessment and Modelling

Ueberlandstrasse 133

P. O. Box 611

8600 Duebendorf

Switzerland

Phone +41 44 823 5012

Fax +41 44 823 5375

Dr. Karim Abbaspour

[email protected]

or:

Elham Rouholahnejad

[email protected]

I cooperate with them in the EnviroGRID Project

Best regards, Ioan Jelev

Dear Rajat,

Check to ensure that the table or query exists. If it does not exist, you can remove all references to it, or if it is a missing table, reimport or relink the table. If it is a missing query, reimport or re-create the query.

Sometimes restarting your computer or resetting the entire model helps in this kinds of situations. Other than that, either something is missing or there is some formating error.

Good luck.

Thanks to all of you for all suggestions.

Make sure that your database is closed when you run the project. I am not quite sure but for my self most times this is the problem

Thanks alot Nabil.

Hi

I have the same problem, have you solved it? can you tell me how

Thanks

Mamoon