Standard compounds to do LC/MS analysis on cotton plant?

More Somaiyeh Ghasemzadeh's questions See All

My output T_diagram in Lumerical_fdtd is not between 0-1, it depends on what?

I simulated a metasurfaces despite the sources amplitude is on 1 but the output diagram for reflection monitor which is DFT monitor is not between 0-1. I don't it depends on something else too or not.

21 November 2022 2,718 5 View

I am working on FT process as part of my project I have a few questions about the power law applied in rate reactions?

Actually I am trying to simulate one of fischer tropsch process based on power law reaction rates. Unfortunately I cannot understand why I cannot get one these graphs in my simulation. I think I...

13 September 2020 5,070 2 View

FEM Code For 2D-Plane strain elements in Python?

Hello everyone, I am about to write a FEM code to analyze the stress distribution in a plate using Python language. I am new in FEM based methods and got confused while extracting the assembly of...

11 February 2020 717 3 View

How can i calculated the evaporated water in close system cooling towers ?

Hi As we know the percent of evaporated water in close cycle cooling towers with indirect heat transfer is less than wet types. I'm going to compare the amount of evaporated water in these towers....

26 May 2018 3,468 5 View

Why the magnetic power of Fe3O4/MWCNTs is reduced after reuse?

my answer is : Because of the physical bonding of the Fe3O4 and MWCNTs, after each time using the nanostructure catalyst the iron oxide nanoparticles are separated from the nanostructure...

21 April 2018 2,465 5 View

What is the Mechanical loading on rotational structures ?

I wanna to calculate the fatigue life of rotational structures, first I need to know their mechanical loads

10 October 2017 7,738 4 View

RNA Extraction Using Hot Borate Method No Longer Working?

I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...

08 August 2024 9,882 2 View

How can major oxides determined by ICP-MS/ES be normalized to 100% volatile free? How does this connect with LOI?

I am analyzing cherts from different sources found within one specific geologic formation using ICP-MS/ES. My committee was asking this question about my analysis. I was not sure how to answer this

05 August 2024 7,902 3 View

Usage of internal standards in LC-MS/MS analysis?

Have you ever seen a LC-MS/MS method uses both internal standards and external standards (in matrix matching purpose) but the concentrations of internal standards are outside the calibration curve...

05 August 2024 3,084 6 View

Are there any commercially available Donkey anti-Alpaca secondary antibodies?

Are there any fluorescently labeled anti-Alpaca secondary antibodies raised in Donkey? So far I have only been able to find anti-Alpaca secondaries raised in Goat. Or is this not possible due to...

04 August 2024 4,255 1 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

How to select relevant metabolites from multiple annotations ?

I am using the Polyomics Integrated Metabolomics Pipeline (PiMP) for metabolite feature analysis. After annotating my data, I have encountered cases where multiple potential metabolites are...

24 July 2024 5,789 0 View

What does negative readings in spectrophotometer denote. Was testing TSS content of bacterial cultures?

I was performing estimation of Total Soluble Sugar content in bacterial cultures by Anthrone method. Out of 9 samples, only one sample showed positive reading while others had a negative reading...

22 July 2024 9,576 4 View

Questions of antibodies selection?

Hi there, I'd like to use immunocytochemistry to determine a surface protein expression on mouse cell. The primary antibody I have is mouse anti mouse, and the secondary antibody I have is goat...

15 July 2024 6,008 5 View

How to purchase metabolites of pesticide standards ?

Penconazole 1. CGA 132465 2. CGA 190503 3. CGA 127841 Fluopyram 1. AE C656948-benzamide 2. AE C656948-pyridyl-acetic acid 3. AE C656948-carboxylic acid I have searched on sigma aldrich as well...

09 July 2024 3,414 2 View

MS/MS spectrum with 5 Da difference in m/z value?

Hi everyone, We experienced a strange pattern in some spectra coming from HRMS/MS analysis. In particular, in the MS1 spectrum a base peak at m/z=M and a smaller peak at m/z=M+5Da appear, but in...

08 July 2024 3,631 4 View

H.N. Nagendra Prasad

Majorly terpenoids are present in cotton, Use GCMS & LCMS for the purpose ?

Regards

Somaiyeh Ghasemzadeh

@ H.N. Nagendra Prasad

Yes. We did GC/MS on cotton plants and identified some terpenoids. I would refer you to this article as well.

Article Identification and functional analysis of two P450 enzymes o...

Sharmin Suraiya

You can read the following paper to know about cotton plant secondary metabolites.

@ Sharmin Suraiya

Thanks for sharing the research paper.