We see sometimes more than one article is published using same data. Though variables may be different and title is different. Is it acceptable in scientific point of view??
Its plagiarism.. It is not accepted.. It is also known as salami paper.. The author can not reproduce same data even his own for another publication..
It's simply plagiarism. We can't use same data in more than one article.
In a recent conference I have seen a poster that expressing some variables only with p values. Like satisfaction score- p= 000, quality of improvement -p=0.843 like that. Is it ok?
02 March 2018 4,460 4 View
I have a questionnaire for a study to see the satisfaction pattern of patients visiting the OPD of a hospital? I am asked to see the Cronbach's alfa? I am searching but also waiting some easy...
03 April 2017 5,068 8 View
Most of the time students suffer with their thesis/dissertation regarding proper guidance and advice in a country like Bangladesh! Supervisors are not satisfied with there students and vice...
10 November 2016 6,201 0 View
One of my colleague is asking me about calculation and interpretation of HR in her thesis!
06 July 2016 8,400 3 View
I want a clear conception regrading these two points so that I can use it in my works! Will anybody help?
05 June 2016 3,381 1 View
I have a data of 100 patients. FVC at normal posture, kyphotic posture and slumped posture. Now how I could command in SPSS for ANOVA to get the p value?
05 June 2016 5,099 4 View
I have done my data analysis by SPSS 20. Article is accepted and editor wants the manufacture details of SPSS-20! Details are available for earlier version of SPSS in different studies! But it is...
07 August 2015 2,755 1 View
When we need to apply Fisher exact test and how to do it in SPSS and how to interpret it there! What are the differences in procedure and interpretation with it with Chi square test? Can anybody...
03 April 2015 5,625 4 View
During risk analysis by multiple logistic regression I am facing a problem! Which one to take into account and which is not. Also after risk ratio calculation we can get OR by cross tabulation....
02 March 2015 9,424 8 View
I am puzzled in choosing of variables as factor and as co variate during multiple logistic regression (MLR) analysis. Can anyone please assist me with example? Is it always necessary to give value...
02 March 2015 1,702 10 View
Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...
07 August 2024 9,563 0 View
I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.
06 August 2024 6,796 3 View
I received an e-mail invitation to join the editorial board of Clinical Cardiology Updates. While I have published a few articles related to cardiovascular disease, there are lots of colleagues...
06 August 2024 8,981 8 View
If the placenta is delivered in squatting position within 3 minutes of the birth of the baby, postpartum hemorrhage is completely eliminated. It works every time. It is quite likely that if a...
05 August 2024 8,895 0 View
need to open an account to upload my published papers
01 August 2024 9,255 1 View
Hi, please suggest some journals where I can publish a observational study protocol.
27 July 2024 2,519 0 View
Please introduce me the latest published articles on the structure and properties of metal nanocomposites?
26 July 2024 2,200 3 View
Does anyone know of any published articles that provide guidance on using TA with multiple team members? I am aware of one (see below), however, there are some disagreements in terms of some of...
23 July 2024 7,819 5 View
How can I find my published papers' total read, citation or any other scores?
21 July 2024 9,802 3 View
Their is new research published in the biological control journal, and I am one of the authors. I want to add it to my account at researchgare. How can I do this?
21 July 2024 7,545 0 View