i have some old para toluenesulfonic acid (it has a a very slight pink tint to it ) , i was wondering if someone can tell me how can i recrystallize it?
thanks in advance
i agree with Petr Slavík but you can using other p-Toluenesulfonic acid (new)
Fa
Petr provided you with good information, however I would like to bring your attention to a very useful youtube
--- https://www.youtube.com/watch?v=smdPlIrqIX0
Good luck
Good qustion, thanks for informaton.
Please have a look at these useful links
http://en.cnki.com.cn/Article_en/CJFDTOTAL-QDHG200805005.htm
I've tested a variety of reagents for the synthesis of a compound and found one that has never been used before and yields a good product. after my experiments i did some research and came across...
08 September 2018 9,071 3 View
sorptivity is defined as the capacity of soil to absorb or desorb water by capillarity. but what does higher sorptivity mean? does it mean the part of infiltartion that depends on capillarity...
06 July 2018 1,715 5 View
Hi everyone I have a question about showing significant difference between treatments in a table using letters. I have 6 total treatments (one control and 5 treatments) like this : Control...
06 July 2018 5,374 6 View
I've seen that the saturated hydraulic conductivity is calculated Darcy’s law and field saturated conductivity is calculated using philip's equation. what is the exact difference between these two...
05 June 2018 2,997 1 View
Hello everyone! In my experiments i have 5 different treatments plus a control, each treatment was carried out 3 times and i wanted to know can i use one way ANOVA to analyze the results? if not...
05 June 2018 7,370 3 View
hi everyone i have some diethyl ether which seems to have some yellow colored impurities, i want to distill it, knowing that the boiling point is ~ 34 °C, it doesn't seem to need much heating but...
05 June 2018 2,043 4 View
what's the best method for synthesis of p-Toluenesulfonic acid doped polyaniline? can anyone suggest some good references? i have found some articles, but they are not very clear. also is...
31 December 2017 4,808 3 View
how is soil pH determined? I see that in some articles a 1:1 ratio of soil to water is used for determination of pH, and in some papers a 1:5 soil to water ratio is used, what's the difference and...
10 November 2017 2,180 16 View
I want to use cellulose in a synthesis but looking through manufacturer's websites to buy it , all i can find is Cellulose microcrystalline . as far as i know microcrystalline cellulose is...
09 October 2017 9,928 5 View
After working with phenol what is the best way to clean the glassware contaminated with Phenol? is neutralizing them with 1M NaOH a good idea?
09 October 2017 7,702 2 View
Approximate concentrations are require in compared with the WHO permissible limts
11 August 2024 2,723 1 View
Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...
09 August 2024 5,444 7 View
I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...
08 August 2024 8,329 0 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View
I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...
05 August 2024 3,290 1 View
I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?
02 August 2024 7,186 6 View
Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...
30 July 2024 435 3 View
I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...
30 July 2024 6,420 1 View
Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...
27 July 2024 5,748 0 View
It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...
25 July 2024 8,738 0 View