what's the best method for synthesis of p-Toluenesulfonic acid doped polyaniline? can anyone suggest some good references?
i have found some articles, but they are not very clear. also is dedoping and doping again,always necessary?
For detail
http://onlinelibrary.wiley.com/doi/10.1002/polb.20503/abstract;jsessionid=24C780CBE1EBF4296DBD6F56E866B89E.f03t02
Organicum. Organish-Chemisches. Grundpractikum. Veb Deutcher Verlag der Wissenschaften . Berlin. 1964.
I've tested a variety of reagents for the synthesis of a compound and found one that has never been used before and yields a good product. after my experiments i did some research and came across...
08 September 2018 9,071 3 View
sorptivity is defined as the capacity of soil to absorb or desorb water by capillarity. but what does higher sorptivity mean? does it mean the part of infiltartion that depends on capillarity...
06 July 2018 1,715 5 View
Hi everyone I have a question about showing significant difference between treatments in a table using letters. I have 6 total treatments (one control and 5 treatments) like this : Control...
06 July 2018 5,374 6 View
I've seen that the saturated hydraulic conductivity is calculated Darcy’s law and field saturated conductivity is calculated using philip's equation. what is the exact difference between these two...
05 June 2018 2,997 1 View
Hello everyone! In my experiments i have 5 different treatments plus a control, each treatment was carried out 3 times and i wanted to know can i use one way ANOVA to analyze the results? if not...
05 June 2018 7,370 3 View
hi everyone i have some diethyl ether which seems to have some yellow colored impurities, i want to distill it, knowing that the boiling point is ~ 34 °C, it doesn't seem to need much heating but...
05 June 2018 2,043 4 View
how is soil pH determined? I see that in some articles a 1:1 ratio of soil to water is used for determination of pH, and in some papers a 1:5 soil to water ratio is used, what's the difference and...
10 November 2017 2,180 16 View
I want to use cellulose in a synthesis but looking through manufacturer's websites to buy it , all i can find is Cellulose microcrystalline . as far as i know microcrystalline cellulose is...
09 October 2017 9,928 5 View
After working with phenol what is the best way to clean the glassware contaminated with Phenol? is neutralizing them with 1M NaOH a good idea?
09 October 2017 7,702 2 View
I vacuum distilled my aniline a while ago but now it has a slight yellow tint to it, i want to use it for polymerization. is it still usable? i would distill it again, but my vacuum system needs...
08 September 2017 9,010 11 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View
Dear readers, Thanks for your attention. I am wondering about the health economic problem of quantifying the value of interventions which a) prevent, b) improve symptom profile and c) ultimately...
05 August 2024 3,246 1 View
I am attempting to conjugate PEG to an amino acid at the C-terminus, for the purposes of producing nanoparticles. I have been told that PEG modified with amine groups can be used for this purpose,...
31 July 2024 2,033 1 View
Hi, researchers, Is it possible to use a safer acid instead of monochloroacetic acid to convert bacterial cellulose to carboxymethyl cellulose?
29 July 2024 4,570 0 View
I am currently performing cell-free DNA (cfDNA) extraction from plasma using an in-house developed kit that employs silica-coated magnetic beads. My protocol works effectively with plasma obtained...
28 July 2024 3,559 0 View
I have been looking for the principle of Cysteine-carbazole-sulfuric acid reaction in research papers and books, but couldn't find it. This reaction is mainly used for the quantification of...
23 July 2024 3,891 0 View
Thanks
22 July 2024 1,143 3 View
Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...
21 July 2024 2,476 2 View
Suppose a material "A" has both tetrahedral and octahedral sites and we are doping another material "B" - usually an ion into it. How can we detect if the dopant has occupied the octahedral site...
17 July 2024 4,299 4 View
Sulfuric acid has changed color to yellow.
16 July 2024 6,964 0 View