raman peaks at 488 and 2448 cm inverse? please help!???

More Raka Paul's questions See All

How to perform Cox proportional hazard analysis or Kaplan-meier survival analysis in SPSS?

At first please see the attachment. This experiment was performed for a period of 7 days (n=100). After 7 days, we found different level of survival rate (%) for each treatment. Now, I want to...

15 February 2021 9,145 2 View

For acid treated montmorillonite clays what will be the result of surface area?

The organo montmorillonite nanoclays modified with octadecylamine were used for the experiment. After acid treatment, the surface area will be increase. However, in my experiment, the surface area...

10 February 2021 1,581 3 View

How to identify when a gaussian program is about terminate normally?

Dear all, I am trying to optimize a bimetallic complex using # opt=tight b3lyp/lanl2dz scf=qc geom=connectivity. The program is running for around 5 days but the size of the .chk remains same...

05 February 2021 8,721 3 View

Can I use 500ng of DNA for restriction digestion?

The recommended amount of DNA for restriction digestion is 1ug in a 50ul rx I've got around 500-600ng of DNA in a total volume of 35ul. Would I get satisfactory results with this amount of DNA for...

31 January 2021 729 6 View

What is the effectiveness of online teaching during COVID-19?

Please share your experience on the effectiveness or challenges on online teaching during Covid-19 lock down. Share your experience about challenges, technology, online learning platform,...

26 January 2021 4,532 37 View

LC-MS metabolomics data after annotation some have their compound name but no KEGG id or with KEGG id but no pathway. How to interprete?

Recently I have generated LC-MS metabolomics data. After annotation, some have their compound name but either no KEGG id or KEGG id but no pathway. How to interpret those compounds? Additionally,...

18 January 2021 1,938 3 View

Has there been any scholarly research done in schools that addresses teaching from a global citizenship perspective to deal with global problems?

The current global pandemic, the climate crisis, the destruction of the oceans (with plastics, etc), and massive numbers of refugees are part of a set of serious global problems. It is clear...

13 January 2021 2,022 3 View

How to remove a citation from list of research articles?

I want to remove a duplicate citation

01 January 2021 3,983 3 View

No executable file generates while building geant4 example code, where is the problem?

Hello, I am a newbie in geant4. I'm learning it playing with example. Sometimes, when I go to simulate an example code, it doesn't create an executable file (the green one in my ubuntu terminal)....

26 December 2020 9,482 3 View

How to get structure and topology for glycosaminoglycan (GAG) of arbitrary length?

Hello all, I want to do glycosaminoglycan (GAG) simulation in Gromacs. Initial structure and CHARMM topology for short chains can be obtained from Charmm GUI glycan modeler. But I have to take...

23 December 2020 6,092 2 View

How two melting peaks in DSC of polypropylene can be merged into one crystallization peak?

The figure shows DSC cooling (blue) and 2nd heating (green) curves (step: 10 K/min) for a commercial sample supplied as Atactic Polypropylene (APP). The heating curve illustrates two major...

03 March 2021 5,857 3 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

What information can be had from raman at higher wavenumber?

i have recorded raman spectra of strontium oxide thin film. the spectra were recorded in the range 400 to 4000 cm-1. i have reference to peaks upto 1000cm-1. but i couldn't find literature for...

26 February 2021 2,499 1 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

How can I find a Raman spectrum wavenumber corresponding to what compound?

I have several Raman spectra with very distinct peaks at certain wavenumbers, such as 277, 359, 466, 583, 623, 686, and 795cm-1. How can I identify them to what compound(s)? The RRUFF and others...

24 February 2021 363 3 View

Genescan gives 3 peaks instead of one?

Hi all, I am doing a genescan analysis for a deleted exon in the patient sample. The amplified region is 215 bp. In the patient sample because of homozygous deletion, no peak is observed while in...

23 February 2021 5,645 1 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View