Quantum mechanical calculation for covalent organic faremwork

More Silpa Elizabeth Peter's questions See All

I have a time series data of some biochemical studies ( DNA and Chromosomal damage) which I intend to use to further predict into future ?

I have a time series data of some biochemical studies ( DNA and Chromosomal damage) which I intend to use to further predict into future without necessarily conducting the assay for an extended...

23 February 2021 7,842 1 View

No mRNA increase in PCR after successful transfection in ARPE-19 cells ?

Hello, i am a bit curious about my results. I transfected the human cell Line ARPE-19 with a Plasmid containing a GFP tagged p53 (p53-GFP, Plasmid #11770). After 24h i checked under the...

18 February 2021 3,811 7 View

Do there exist stand-alone permanently in-ground soil-moisture sensors with an installed GSM module, for outdoor use?

Am searching for a stand-alone permanently in-ground soil-moisture sensor with an installed GSM module, for outdoor use. The idea is for the sensor to send a moisture reading via a cellphone text...

04 February 2021 2,047 4 View

What is the easiest way to remove the water from organic solvents?

Hello everyone! I have one question. I have couple of solvents and all of them were pure when they were bought but after some months or years of storage after opening I am not 100% sure about...

03 February 2021 2,154 8 View

Virus neutralization assay in BSL2 lab?

Hi I want to set up a virus neutralisation assay such as PRNT or FRNT at my lab (BSL2), but im uncertain of the bio safety requirements that has to be fulfilled in order to work with...

01 February 2021 5,626 3 View

Using LINK11 to Apply force in ANSYS APDL?

I'm trying to use LINK11 to apply a force as if it was a cable pulling a structure twowards a point in ANSYS APDL. When I solve the model, the deformation of the overall structure is far too...

30 January 2021 7,919 1 View

Cytoflex Flowcytometer, clotting issues and cleaning procedures?

We have been having clotting issues with our Cytoflex S from Beckman Coulter. Back in December 2020, we had to have the tubing system and sample needles replaced, but we are beginning to observe...

28 January 2021 6,897 2 View

Difficulties purifying Outer Membrane Vesicles using a Sucrose Density Gradient: Unable to detect any protein after this process?

I'm currently trying to purify Outer Membrane Vesicles (OMVs) following their extraction from the bacteria I'm working with. After the initial extraction the concentration of protein seems good...

27 January 2021 6,852 3 View

What excamples do you know wasting unused contents of "empty" packaged products?

Most of us use tooth paste more times a day. The empty tube we throw away. I wondered how empty the tube really is. This does not sound being Research? I began to collect empty tubes...

19 January 2021 808 3 View

What is the largest disadvantage in using of face masks at present? What would you like to be improved?

We all use face masks many hours a day. I wonder what are your items you like to be improved. We have the opportunity to write an application for support to a sponsor. Your answers will help us a...

18 January 2021 1,311 4 View

Chlorinated organic formation in odor control scrubbers using hypochlorite?

I'm involved in a study of odor control technologies for municipal wastewater treatment plant. One of the control options involves a chemical 2-stage (acid/alkaline) packed bed scrubber. The...

03 March 2021 3,661 2 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

How does Scientist/RG community evaluates a case study article and the impact of it on a researcher career?

An article that is published as a case study in the SJR listed journal. How much value is added to a researcher career? How it is evaluated by a scientific researcher/University admission...

02 March 2021 9,661 3 View

How Relativistic effects is one reason for lanthanide contraction?

The Lanthanide contraction which is the decrease in ionic radii of the elements in the lanthanide series from atomic number 57, lanthanum, to 71, lutetium, is due to poor shielding of the 4f...

01 March 2021 2,272 4 View

Ester cleavage conditions?

Hi all, I need to cleave the ester in Ethyl 2-amino-1H-imidazole-5-carboxylate to make the carboxylic acid and retrieve the product from solution to use in downstream applications of linking to...

01 March 2021 8,766 3 View

Can polymer concentrations be calculated based on the number average molecular weight?

Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...

28 February 2021 7,882 2 View

Is there a deep reason for using the squared modulus of the wave function as the probability density of the existence of the particle?

I think we were all surprised at the first time we got to know quantum mechanics that the squared modulus of the wave function is the probability density of the existence of the particle? The role...

28 February 2021 6,282 9 View

How can we theoretically calculate Elemental analysis(percentage) of atoms in covalent organic framework?

For example in one research article the Elemental analysis values of COF-TpPa-1 ( Triformylphloroglucinol (Tp) (63 mg, 0.3 mmol), Paraphenylenediamine (Pa-1) (48 mg, 0.45 mmol) are as follows...

24 February 2021 1,265 6 View

How do you mesh a thin solid in Fluent?

Hello, I have used the shell function on SpaceClaim to create thin solids for the model I am studying. These are contained within an enclosure for my study. I chose this approach as it avoids the...

24 February 2021 8,856 3 View