What is the allowed time to transport of blood to patient after the working the cross match to the blood ?

What is the correct time to transport of blood to patient after the working the cross match to the blood?

07 August 2017 5,044 4 View

Over 70% of all medical decisions are based on laboratory results ?Why ?

07 August 2017 1,294 2 View

Which the biochemical parameters that can be used to helping in diagnosis the cause of dropping the hair ?

07 August 2017 5,409 4 View

Ph value for venous blood is lower than in the arterial blood ? why

05 June 2017 3,908 4 View

No title

05 June 2017 2,707 2 View

How to determine the acid-base imbalance in the human blood.....

The pH should be checked first i think ....

05 June 2017 7,213 4 View

Most laboratories consider less than 7.20 and greater than 7.60 the critical values for pH.

I don't know why the Most laboratories consider less than 7.20 and greater than 7.60 the critical values for pH.

05 June 2017 7,507 5 View

A renal-type aminoaciduria

05 June 2017 2,216 4 View

Creatinine synthesis increased in pregnancy, but plasma creatinine is usually low? Why

05 June 2017 7,840 3 View

Hepatic coma

05 June 2017 2,023 0 View

Is there any test to determine the cardiovascular risk of patients with obesity? from the perspective of obesity?

We found tests to determine cardiovascular risk taking into account lipid profile, blood pressure, age, history of diabetes, other laboratories. But when weight is involved, there is a paradox. I...

02 March 2021 6,036 1 View

What SPSS analysis should I run with one IV (with two levels) and two DVs?

Hi, I am trying to figure out which test would be most appropriate to run for the following question: Is there a difference in task blood pressure between smokers and non-smokers? There are two...

01 March 2021 8,235 2 View

How to quantify carbon deposition on CuZnAl catalyst?

Dear All, I want to quantify carbon deposition on the surface of the CuZnAl catalyst. I have tried thermogravimetric analysis, but I've got weight gain as the active Cu- get oxidised. Does anyone...

01 March 2021 1,907 3 View

Why Trivalent chromium start precipitating above PH 5 ? Moreover discuss difference between adsorption of chromium and precipitation of chromium ?

I am a student of MS Environmental Engineering and started my research phase. I am working on metal removal ( chromium iii ) by using activated carbon prepared from the agricultural feedstock. So...

01 March 2021 5,475 2 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Can polymer concentrations be calculated based on the number average molecular weight?

Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...

28 February 2021 7,882 2 View

What could be some reasons why unstimulated monocytes are getting activated?

Im doing PBMC isolation -> CD14+ enrichment using magnetic beads -> stimulation setup. My negative control is just cells in cRPMI but they seem to get activated over and over again.

28 February 2021 7,883 3 View

How can I assign a velocity along one direction to CO2 molecules in a molecular dynamics simulation using GROMACS?

Dear all, I am trying to perform a MD simulation about the interaction between CO2 and a polymer. I create my model, solvate it and perform the NVT and NPT equilibration. Now I am not able to...

26 February 2021 10,014 3 View

CGA 300 Regulator for CO2 cylinder?

Has anyone ever tried to deliver CO2 with a CGA 300 regulator? I know that a CGA 320 regulator is standard for CO2. The issue is that I currently do not have any free CGA 320 regulators. I also...

25 February 2021 3,292 3 View

Reagents for histology slides?

Dear all, I am planning to study histology and want to do that at home. I have only stained a blood smear with Giemsa but now want to try a wider range of animal tissues. What reagents will I...

24 February 2021 5,430 3 View