Dear all, Iam currently working on Dc Microgrid model for electrical vehicle charging. Can any body give good IEEE research paper on this topic?

please give any suggestion?

04 February 2021 4,837 5 View

What does the change in D-peak position in Raman spectroscopy of carbon materials indicates?

We have carried out high-pressure Raman characterization on some of our samples. After fitting, I have observed a change in D-peak position with increasing pressure. What does this change...

20 January 2021 853 3 View

PSFB control signal?

Hi everyone iam facing a problem to give control signal for switches in design of PSFB converter in matlab simulink. Anybody's help will be appreciated.

14 December 2020 6,021 3 View

What are the alternative to the pozzolanic materials to in concrete to enhance the durability of concrete?

As of now, Only industrial wastes were using as pozzolanic materials in concrete to enhance the durability of concrete. Can any once suggest me the alternatives of those materials?

11 October 2020 3,569 4 View

Can any one suggest me the dielectric constant of Gold and Co3O4 at room temperature ?

i have a question regarding dielectric constant of gold,cobalt oxide (co3O4) and n-tpe silicon . i find only one publication on this issue showing dielectric function cobalt oxide(CoO) 12.9 and...

02 October 2020 9,138 4 View

Eupergit beads for enzyme immobilization?

We are looking to immobilize some of our enzymes on Eupergit beads. I was wondering if you know any commercial supplier of Eupergit beads?

28 September 2020 5,664 3 View

Can somebody kindly suggest a good FEM software for the numerical solution of stochastic PDEs?

Please kindly suggest some good FEM softwares for the numerical solution of both time-dependent and time-independent stochastic PDEs.

28 September 2020 6,598 4 View

How to run Seismic analysis for the following model in OpenSees..?

I have developed a 3 bay 5 story 2D frame in Opensees but I have problems with element load and application of seismic load in Opensees using an acceleration file. I always got an error namely...

27 September 2020 5,885 4 View

How can we evaluate the conductance of a constant power load (CPL)?

Any CPL is modeled with a current source in parallel with negative resistance. How do we evaluate the negative resistance, if we know the constant power consumed by the load?

19 September 2020 6,188 3 View

How to learn the modelling of RC beam subjected to 4 point bending in Ansys Mechanical APDL?

I need to model a reinforced concrete beam subjected to 4 point bending. I also need to plot the load vs displacement at mid span and compare it with the experimental data. Bond between concrete...

10 September 2020 9,004 4 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Trouble with Charting with Google Earth Engine (Technical)?

Hello. I have a problem with the charting in google earth engine. I created an image collection by combining 5 image collections of five parameters and using ee.Join.inner ( ) and .apply ( )...

26 February 2021 7,084 2 View

Modeling viscosity using model of Chung?

Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...

25 February 2021 8,053 5 View

How do I plot Pressure against crank angle degree in Fluent?

18 February 2021 8,390 3 View

Can any one explain why the ethyl ester Biodiesel (FAEE) has higher than that of the metyl ester FAME- both of them are derived from the same oil?

Biodiesels derived from waste vegetable oil transesterification with Ethanol (FAEE) show higher peroxide values than those derived by transesterification with methanol (FAME) prepared under the...

13 February 2021 193 6 View

Which one is better for storing energy: Fuels synthesized from CO2 or Hydrogen?

Based on educated guesses, which one of the following promises a better future for storing energy for grid scale, automobiles etc as opposed to batteries: 1) Fuels synthesized form CO2 2)...

02 February 2021 8,741 6 View

I want to extract engine oil from a soil sample,please how much amount of anhydrous sodium sulphate am i going to add to 10kg soil?

Engine oil extraction from contaminated soil,10kg of contaminated soil+20ml of dicholoromethane+? of anhydrous sulphate

01 February 2021 9,509 1 View

Is it necessary to have internal standard in Bio analytical Method Validation in HPLC?

Please suggest a suitable reference from I can get information regarding the internal standards and other calculations for bioanalytical method validations for HPLC.

19 January 2021 5,680 5 View

At what step should one add internal standards in tissue sample for LC-MS?

Hi everyone, I'm doing metabolomics of placental tissue in my lab. I added 1ml of 80% MeOH along with 2 isotopic internal standards namely, phenylalanine and palmitic acid to my sample after...

18 January 2021 9,520 4 View

How to build aero engine fuel system online prognostics simulation model using Matlab, Simulink and Simscape?

How to build aero engine fuel system online prognostics simulation model using Matlab, Simulink and Simscape?

17 January 2021 5,181 1 View