While searching MOSFET in digikey using filter ,there are filters options are like
1.Drive Voltage (Max Rds On, Min Rds On)
2.Rds On (Max) @ Id, Vgs
3.Vgs(th) (Max) @ Id
now my driving voltage is 3.3V(Arduino),so will it be a problem if i am using selected mosfet in the attached file for switching operation?
For my application required drain current is less than 100mA.
Nikolay Pavlov
You should filter/use 'Logic Level Gate' MOSFETs or at least make sure that the datasheet shows >>100mA drain current at Vgate_source =3.3V
0 votes
0 thanks
Biswajit Singh
Thanks Pavlov,
could you please explain why there is a two Vgs voltage is mentioned when i am filtering Drive Voltage (Max Rds On, Min Rds On ) ?
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Organizational Psychology
- Training
More Biswajit Singh's questions See All
Similar questions and discussions