MIM structures, hybrid SPP-waveguide mode structures exhibit much higher performance as compared to prism based SPR sensor? Is it true?

05 April 2023 0 3K Report

There are some merits of prism based sensors also when compared to MIM..

Any feedback?

Badges
Science topic

More Arun Uniyal's questions See All

What may be the reasons for failures of Tube toi Tube Sheet Joints in Boiler Drum ?

We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.

08 August 2024 3,161 0 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Hello everyone！ I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...

05 August 2024 5,729 2 View

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...

03 August 2024 5,358 0 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

What is the most appropriate statistical test to perform when comparing the percentage of 2 cohorts that have a particular mutated gene?

I am using GraphPad prism for data visualisation and analysis. I am trying to assess if there is a statistically significant difference between the percentage of 2 cohorts (patients and cell...

17 May 2024 4,424 1 View

Calcul IC50 rélatif par graphpad prism 10 ?

Bonjour, 1. Comment déterminer l' IC50 rélatif du test MTT par le GraphPad Prism 10 ? En effet, j'ai un résultat pour la dose maximal utilisée est de 60% de perte de viabilité et non pas à 100...

09 May 2024 5,759 2 View

Has the formation of my silver nanoparticles been indicated by the provided UV-Vis spectrum?

I'm trying to produce silver nanoparticles using plant extract, but I didn't observe the expected peak in the UV-Vis spectrum between 380-420 nm, where silver nanoparticles typically appear. After...

04 May 2024 6,463 11 View

What to do about some data sets being normally distributed, some being normally distributed after log transformation and some not norm. dist. at all?

Hi all, I have collected some data from 3 treatment groups (n=5) with relation to 6 markers of fibrosis. When I was looking to analyse (with GraphPad Prism) these 6 data sets, I noticed that some...

11 April 2024 7,526 3 View

How to use graph pad prism program?

Any idea folks?

05 April 2024 8,932 0 View

Surface mass of a BLI (Bio-layer interferometry; Octet) Measurement?

Hello together, I am looking for a conversion factor for BLI (Bio-layer interferometry) from the nm values into a more comparable pg/mm2? For SPR it seems to be common to convert the RU values...

13 March 2024 6,238 0 View

About measuring the resolution of equilateral prism?

Actually, for producing an optical comb with prism and etalon, the resolution of the prism must be less than the FSR of etalon. Could anyone help me how to calculate the resolution of a prism?

20 February 2024 9,131 0 View

What could account for the presence of dual surface plasmon resonance peaks in the UV-Vis spectrum of silver nanoparticles?

Respected scholar, I have synthesized bare silver nanoparticles using sodium borohydride reduction at room temperature and measured their UV-Vis absorption spectrum. The spectrum showed two...

26 January 2024 3,191 3 View

Someone could help me to solve a difficulty in establish the parameters for Km analysis (Michaelis Menten)?

I'm trying to establish the Km for different substrates for a specific enzyme, however, at every attempt a new doubt arises. This is a new field of knowledge to me, so any suggestion will be...

22 January 2024 8,748 6 View

Which non-linear Regression option shall I use to calculate IC50 using Graphpad prism?

Hello/Salam Everyone, I'm using GraphPad prism to calculate the IC50 of some drugs in cancer cell line and impact of drug B on the IC50s of these drugs. As per my calculation method, to conduct...

20 January 2024 7,527 0 View