Middle Frequency in EIS Method

26 May 2017 0 2K Report

I am using Zive SP1 to as a platform to conduct four-probed proton conductivity measurement. In the setup interface, I am required to key in initial, final and middle frequency. Can anyone explain what is middle frequency?

Badges
Science topic

More Min Yan Chia's questions See All

Whether i can preserve leaves samples in 2.5% glutaraldehyde in 0.05 M phosphate buffer, pH 7 for coming several weeks for further LM study ?

I want to preserve the sample leaves for the LM study of the stomata and conidia analysis. Whether 2.5% glutaraldehyde in 0.05 M phosphate buffer with pH 7 can be applied for preservation.

29 July 2024 8,560 0 View

Is CFI / TLI = 1 okay in Mplus?

Hi there, I did a CFA to 10 items on 2 latent variables. The model fit is too good and I've never seen it before. CFI / TLI = 1, RMSEA = 0. Is it okay, if everything else was done properly?...

24 July 2024 5,454 7 View

How much 1X TAE buffer should I use in preparing 1.2% agarose gel?

Commonly, we prepare 1.0% of agarose gel with 0.4g agarose powder and 40ml 1X TAE buffer. if I would like to prepare a 1.2%% of agarose gel, is it I need to add 0.48g agarose powder and 120ml 1X...

12 July 2024 2,058 5 View

How do I link researchgate with my pubmed publications?

I moved to a different institute and changed my email address. Somehow I lost the list of my publications. Is there a way to link to my PubMed publication list?

17 June 2024 5,312 2 View

Synthesis poly(N-isopropylacrylamide) through ATRP by using CUBr/PMDETA?

Monomer: NIPAM; Initiator: BiBB; Catalyst: CuBr; Ligand: PMDETA I added CuBr and the mixture was blue, after that, I purged with nitrogen for 30 minutes and the mixture turned green. The mixture...

27 May 2024 9,144 1 View

What mode can confocal microscopy use to observe metal surfaces?

How can confocal microscopy observe cells stained on metal surfaces

28 April 2024 2,804 1 View

How can confocal microscopy observe cells stained on metal surfaces?

How to observe cells stained on metal surfaces using confocal microscopy,How to adjust the confocal mode

28 April 2024 3,103 0 View

Is it OK that the sample in CFA is smaller than EFA?

Our research team is developing a scale. We have conducted EFA with a sample of 798 Chinese university students. And since there are 34 items in the scale, we plan to conduct CFA with a different...

17 April 2024 4,399 4 View

Does anyone have B3Z T cell hybridoma?

I need B3Z T cell hybridoma in my experiment. It is not commercially available. Can someone share some with me? Thanks very much!

14 April 2024 1,532 3 View

Extration of myosin?

Hello, I want to extract myosin from chicken breast. The operation is as follows: (1) the miced meat was washed with buffer A (0.1 M NaCl, 10 mM phosphate buffer，2 mM MgCl2, 1 mM EDTA, pH 7) for...

02 April 2024 365 2 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View

What procedure should I follow for current controlled PPy film electrochemical deposition on ITO?

For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...

06 August 2024 3,176 0 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

What are the shear and normal stiffness values of an LLDPE liner in 3D numerical modeling of a stockpile?

I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...

05 August 2024 3,665 0 View

Why don't d-orbitals split themselves, why does it take a ligand? why don't protons from ligand repel nucleus split d-orbitals?

why don't d-orbitals split themselves because of themselves without the presence of ligands? Electrons are indistinguishable. Why wouldn't it be more correct that protons from a ligand split the...

03 August 2024 3,589 3 View

Why doesn't chromium 2+ ion use all its d-orbitals to receive lone pairs from six waters in [Cr(H20)6)]3+?

I'm guessing it's because the ligand experiences too much electron repulsion or proton repulsion from the chromium to insert them close to the 3d-orbitals which are close to the metal nucleus. Is...

03 August 2024 1,370 1 View

Why aren't most metal oxides insoluble in water?

Why BaO (s) + H2O(l) ---> Ba 2+(aq) + 2 OH - (aq) if Oxygen loves owning all the electrons, why would it bind to hydrogen which competes with Oxygen for electron ownership more so than...

03 August 2024 5,392 1 View

What do you consider to be the most relevant elements of EEG for studying cognitive biases?

I've seen articles that primarily focus on alpha and beta activity in the frontal regions, but these studies often compare healthy subjects with those having various pathologies. I haven't seen a...

31 July 2024 7,259 1 View

Mossbauer spectroscopy Co0.6Mn0.4Fe2O4 MNPs?

Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.

31 July 2024 9,140 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View