Maximal balooning in stoma that can be tolerated GIT fluoroscopy procedure?

01 January 1970 1 10K Report

When we do fluoroscopy from ileostomy, colostomy,I use insert catether in stoma, but without balooning it can reflux. so I doing balooning in stoma, anyone know how much balooning in diameter, we can do in ileostomy and colostomy?

Claudio Bencini

A foley catheter currently fits to ileostomy, and in colostomy too in many cases.

Anyway you can try an irrigation set, too

Badges
Science topic

Similar topics
Social Psychology
Attitude

More M. Ricky Ramadhian's questions See All

Is there any cases algae not using the nutrient from the wastewater and grow normally?

I am working on microalgae cultivation using waste water. The initial concentration of nutrients were less but the microalgae has achieved biomass growth of 2 g/L. The final concentration of...

08 August 2024 4,812 2 View

I have calcined my catalysts without flowing air from the compressed air cylinder will there be any problem with my reaction if i use that catalysts?

FYI Catalyst is MFI zeolite Si/Al = 140,25.40.11.5,15 I am using this catalyst to study methanol to DME conversion

25 July 2024 2,486 2 View

How can I measure arsenic concentration in a patient blood?

I intend to get an economical and accurate LAB TEST to measure arsenic concentration in blood sample.

23 July 2024 3,654 2 View

It is possible to conduct a structured written interview for a qualitative study?

In your opinion, I would like to know if a qualitative study with a structured interview can be conducted in writing. In other words, we sent out open questions and asked the interviewees to...

11 July 2024 4,163 4 View

What is Differential-Fed in microstrip patch ant? How it is design in CST studio? What is process and procedure to do Differential-Fed in CST studio?

What is Differential-Fed in microstrip patch antenna ? How it is design in CST studio? What is simulation process and procedure to do Differential-Fed in CST studio ?

08 July 2024 7,464 1 View

How to know the TM/TE modes in antenna design in CST studio?

How to know the TM/TE modes in antenna design in CST studio? Example: TM01 ,TM02 ,TM10, TM12, TM30 like this... how can identify the antenna is operate the above said mode? can any one explain...

08 July 2024 6,609 2 View

What is co-polarization and cross polarization? How can plot it from CST studio?

what is co-polarization and cross polarization? How can plot it from CST studio? what are steps and process for find out co-polarization and cross polarization from CST studio?

08 July 2024 7,869 1 View

Why in some degradation experiment the results doesn't fit first or second order kinetics ?

In an antibiotic degradation experiment using metals carbon composites to activate PMS, the results doesn't fit pseudo first or second order kinetics however the degradation efficiency is very...

26 June 2024 6,941 3 View

Why carrier Concentration decreases while increasing Temperature ?

Hi All . Recently, I conducted Hall measurement experiments at high temperatures on highly p-doped diamond with a doping concentration of 2.5×10^20 cm−3 During these experiments, I observed two...

23 June 2024 4,763 0 View

What are the best practices for increasing earth biomass?

I'm thinking of how to increase biomass to replace plastic and industrial waste.

23 June 2024 1,871 4 View

What is the ionic radius of Hydrogen anion? And how to know the exact ionic radii of the elements?

I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...

01 August 2024 2,614 1 View

Does anyone have information on the tolerance in different animals after i.v. administration of nitisinone?

I am interested in the safety/toxicity of NTBC administration in different animals. There is a lot of data available relating to oral administration however limited data on intravenous administration.

04 June 2024 5,628 1 View

How measure tolerance factor of BaSrCaTiO3 perovskite?

for ABO3 if only A & B then we used t=rA+Ro/sqrt2(rB+rO) kindly explain for BaSrCaTiO3 ?

31 May 2024 2,036 0 View

Could anyone provide the source code to plot basin of attraction of a map (like logistic map or something else)??

I want to find basin of attraction for delayed logistic map like this: x(n+1) = A*x*(1-x(n)-B*x(n-1) I wrote bellow (MATLAB) code, but it just show three basin of attraction for given parameter...

21 May 2024 1,686 0 View

How to correctly simulate PWAS Sensor in Abaqus?

I am fairly new to Abaqus and would be happy for any advice. The problem: I have a round solid sandwich panel, which is situated between two shell elements. In the middle there is a...

02 April 2024 8,748 0 View

When is a cell line considered radiosensitive?

Dear readers, I am currently performing radiosensitivity assays on tumor cell lines, both using clonogenic survival and cell viability (cell titer glo). I was wondering whether there are some...

02 April 2024 7,273 2 View

Hi, could anyone suggest me drought tolerance index for conifer species seedlings? I only get literature about drought tolerance index for crops?

can we use crop drought tolerance indexes for conifers as well?

25 March 2024 6,365 1 View

Fault tolerant Backbone Wide Area Network (WAN) using Cloud Computing and SD WAN ?

i am doing a project titled "Fault Tolerant Backbone Wide Area Network (WAN) using Cloud Computing and SD-WAN," and l am looking for an expert view and comments on the topic ,as well as thoughts...

20 March 2024 7,465 0 View

How can we induce drought stress in rice plants in vitro? What methods measure stress( MPa) accurately?

This question seeks to explore the techniques for inducing drought stress in rice plants in laboratory conditions and methods for accurately assessing the resulting MPa stress levels. It aims to...

17 March 2024 5,840 0 View

In an experiment, what is the priority of applying abiotic stresses and applying foliar treatment with a plant resistance inducer solution?

Factor 1: Abiotic stresses (such as heavy metals, drought, salinity, etc.) Factor 2: Foliar spray treatment with a plant resistance inducer solution a) First stress treatment, then foliar spray...

28 February 2024 944 4 View