Hi everyone. I am trying to get load vs displacement graph in ABAQUS for pull through failure of bolted joints in composites. I am using two circular plates with a hole.The plates are joined together with a cohesive layer in between. There is a bolt in the hole. I am applying a displacement bundary condition on a reference point on the bolt. However I am not getting any curve. Could anyone guide me on this.
Kind Regards
Hi. You should draw RF v.s Time and U v.s. Time for reference point from "x-y plot". Next use RF and U data from "x-y plot manager" to draw combined curve of load v.s displacement.
Dear Meysam, I have already done that. However I get no curve at all individually and combined together.
Dear Moazzam, did you choose the node on which the reaction force is applied?
Also you can combine the two graphs with the function ''combine()''
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Materials Science
- Plating