How to calculate the crystallinity of cellulose film?

27 February 2021 2,753 4 View

How does GROMACS calculate the average structure of proteins?

I want to get a average structure from a pdb file containing multiple models. I used the command below: gmx cluster -f input.pdb -s topol.tpr -cutoff 20 -method gromos -av GROMACS...

25 February 2021 6,314 1 View

No title

The regenerated cellulose film was prepared by zinc chloride/H2O system. The zinc chloride had been washed away in the regeneration process, and the wet film which was not dried had uniform...

18 February 2021 9,538 1 View

Can ethanol be used as an analgesic?

If ethanol has analgesic properties, why isn't it used for clinical purposes?

18 February 2021 8,227 4 View

How to decrease the time for publication of paper in a journal ?

It takes a lot of time in publishing the paper in the journal, from few months to a year so how one can able to decrease the time for publication.

17 February 2021 2,997 14 View

Which statistical test is best to seperate out treatment effects meta-analysis?

I am doing a meta-analysis and am looking for some guidance on which statistical test will help me do the following. I want to understand the effect size a treatment has on a population. There...

16 February 2021 8,033 3 View

R/Python package for time-intensity or progressive profiling in sensory evaluation?

Hi I've been looking for a stat package for my sensory evaluation data (progressive profiled which is a multi-timepoint version of descriptive analysis). Is there any available one to...

08 February 2021 9,170 3 View

How can I make sure the simulation results of the water droplet impacting on the wall using the FLUENT agree with the experimental results?

Dear researchers, I am modeling the process of the water droplet impacting on the wall with a constant contact angle. The specific calculation parameters are as follows: The droplet diameter is...

24 January 2021 1,020 5 View

Forced Vibration Testing using FDD?

Hi, Can we use FDD algorithm for forced vibration response (sinusoidal response produced from eccentric mass vibrator)? Thanks

22 January 2021 5,851 2 View

What should my objective ?

I am going to start my master program (msc agri hons) research in rull of potassium in tomato vigetable crop so what should my objective please guide me Thanks

13 January 2021 4,635 6 View

What element is driving the different slop in the low frequency tail?

My study consists simple corrosion inhibitors in salty brine. Right now I just fit my circuit with randles with CPE. Just wondering how the slop can given more info of the experiment. Or any...

01 March 2021 6,474 3 View

How to model the battery pack in PSIM or PSCAD?

Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...

28 February 2021 2,116 1 View

Does the circuit modeling for planar monopole antennas using Foster canonical forms give good approximation?

Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...

28 February 2021 7,016 1 View

How to design a boost converter for a mppt controller?

I have a doubt on how to select the inductor and capacitor value when I want to implement MPPT controller. This is because we always take a maximum output voltage and current but in this case, we...

28 February 2021 3,637 2 View

For modelling epoxy-based matrices (in composites), which model in ABAQUS is the most suitable, Concrete damaged plasticity or Drucker-Prager model?

I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...

28 February 2021 5,415 1 View

In frequency domain alpha band(8-16hz), beta band(16-32hz), gamma band(32-64hz), sub-band(64-128hz) are same as LL,LH,HL,HH in wavelet decomposition?

I am working on single trial motor imagery data i.e. EEG data. I am following a paper which has a dataset from BCI challenge IV (dataset 2b). After removing noise and extracting all the data from...

23 February 2021 5,503 1 View

How can misfit between business requirents and ERP system business process be reduced?

One main reason for failure of most ERP implementations is the misfit between business requirents and ERP system business process be reduced. How can the misfit between business requirents and ERP...

22 February 2021 5,709 5 View

Suppose we have a banana seller cart consisting of 4 wheels, weighing about 300 kg. How much torque motors are needed to pull of push it electrically?

I am thinking of electrifying the street food carts while harvesting energy using solar panels on top.

22 February 2021 4,323 3 View

PMSM Inter Turn Short Circuit fault, Dataset?

Hi, I'm looking for a dataset of a PMSM with an inter turn short circuit fault. Does anyone know a dataset which is available?

21 February 2021 5,663 2 View

How to perform Kaplan-meier survival analysis in SPSS?

Hi everyone, This is my first time of attempting to run survival analysis. I have a data on patients with End-stage Kidney Diseases (ESKD). I would want to run survival probability by treatment...

16 February 2021 2,647 3 View