08 October 2020 2 2K Report

Hi,

I connect Lock-in Amplifier(SR530) with GPIB-USB.

After I scan device with Measurement&Automation, the address of instrument can be found. 23 based on the manuanal.

but as I send data request commend *Q1"or "QX"..... balala... I cannot get the value from this SR530.

The MAX could find the address while the error code is always -1073807339 as I send the command. I did not get any value from both Channel 1 and Channel 2.

May I know the Labview version you used and "SW1:GPIB Mode Switches" and "SW2:RS232 Mode Switches" of your SR 530?

By the way, have you added a 270 pF capacitor in your SR 530 as suggested from Official website?

I do need your help for this problem. Many THX

Best regards,

SHUEN W

More Shuen Wei's questions See All
Similar questions and discussions