Dear Mr. O. Ennaya,

please, select the tab of results and then tab graphics and animations, select option contours then contours of, select the temperature in cascading menu and, then option total temperature or static temperature, depends your simulation or analysis.

Note: for streamline, repeat The steps above and, select velocity then streamline or stream function.

sincerely,

jafar behtarinik

Dear Mr. Jafar Behtarinik ,

I know that but i'm asking to do this at different instances in the post processing cuz i don't find time option.

cordially.

Dear Mr. O. Ennaya

please, pay attention to the attached picture. any question?

best a luck

jafar behtarinik

good morning Mr. Jafar Behtarinik

Thank you for your feedback....i will try this.

thank you again.