hi, i need some articles about interaction between tunnel and metro station in projects, is there anybody help me?
Hi Majid
There are a lot papers about your topic especially in "Tunneling and underground space journal". You can follow bellow links:
http://www.sciencedirect.com/science/article/pii/S0886779811001611
http://www.sciencedirect.com/science/article/pii/S088677980900087X
http://www.sciencedirect.com/science/article/pii/S0886779811000836
http://link.springer.com/article/10.1007%2Fs10706-013-9706-7
http://onlinelibrary.wiley.com/doi/10.1002/geot.200800022/full
http://onlinelibrary.wiley.com/doi/10.1002/geot.200900026/full
Hello everyone. I want to know what effect have on the surface settlement in the urban tunnels when the soil is saturated? Thank you
07 August 2018 7,392 0 View
Hi everyone Is there a source for code writing in MATLAB to analyze the stability of the key blocks created in the tunnel? We want to identify key blocks in this code and see if these blocks are...
07 August 2018 2,363 0 View
Hi, I wanna design damage and also know what happen in rockburst. so I need to know which software have to use or which books and papers I have to study. also experience and everything that is...
06 July 2018 9,918 0 View
Hello dears. I wanna analyze a tunnel under seismic load that it has temporary lining ( shell as S/C and beam as steel set) and we have to install of permanent lining for this analysis. My...
03 April 2018 490 3 View
Hello, What is difference between boundary conditions in FEM? when we use viscose BC, absorbing BC and free field BC? What is difference between underground structure and surface structure in BC...
07 August 2017 293 2 View
hi..do you have information about construction of tunnel below the water...How can water be controlled? methods are NATM,ADECO_RS,C D,... like freezing,grouting or other methods!!
05 June 2016 3,103 2 View
I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?
25 February 2021 9,761 1 View
Hello, I am running a sandwich-type ELISA where I am trying to inhibit a protein-protein interaction using small molecules. For each experiment, I determine my Z' (Z-prime) to determine the...
23 February 2021 7,429 1 View
How to build fluid structure interaction simulation for elastic ring squeeze film damper in COMSOL?
22 February 2021 5,408 1 View
We have deposited silicon carbide on carbon substrate using one PVD technique. Due to amorphous behavior of SiC at low deposition temperature, we performed heat treatment of those films at...
22 February 2021 2,072 3 View
We are conducting a pilot study of an intervention for informal caregivers of persons who have recently received a bone marrow transplant in the US. If you know of anyone who might be interested,...
13 February 2021 9,174 1 View
My study consists of a conceptual framework with seven constructs measured in seven point Likert scale. According to pilot study, only three constructs have Cronbach alpha value more than 0.9...
12 February 2021 9,368 2 View
Possibily not an open access journal which does not add any publishing costs once being accepted. Thank you in advance
09 February 2021 717 6 View
I have attempted the formylation of the above mentioned compound using a very well reported protocol using secondary Butyl Lithium and TMEDA at - 78 degrees Celsius. I have done it quite a few...
08 February 2021 2,793 2 View
I am trying to run a molecular dynamics simulation for a ligand that contains a "SEP" residue. also, I am preparing my files using Charmm-GUI using charmm36 ff, but it says that it will rename my...
31 January 2021 6,321 1 View
Hello, I am conducting a sandwich-type ELISA. It is to see if small molecules can interfere with a protein-protein interaction. As this interaction would occur in the human body, may I heat...
31 January 2021 4,271 3 View