What is use of PID controller in DC motor?

10 November 2016 8,991 0 View

Can u say the differences between IEEE and IEEE explore?

I have uploaded my paper in international conference they have mentioned that they will publish in IEEE explore

10 November 2016 6,702 6 View

Inside the petrol engine during combustion process how much temperature will be there?

10 November 2016 4,635 1 View

What is the difference between arc welding and gas welding?

basis of properties

10 November 2016 9,519 0 View

What are the parameters to be considered for modelling solar still ?

10 November 2016 2,597 3 View

Which gas is having low specific head and cost?

09 October 2016 6,558 2 View

How can i determine the efficiency of solar pond theoretically?

Solar pond

09 October 2016 4,785 8 View

How to analyze solar pond in ANSYS?

Fabricated with MS sheet with tickness of 2mm ans insulated with HDPE and themocole and salt having concentration of 35mg/litre

01 January 1970 5,664 1 View

Is glass or fesnell lens is cost effective for covering solar pond?

Solar pond will be affected by rainfall, wind etc.,

01 January 1970 642 1 View

Which material is suitable to store temperature in solar air heater?

Solar air heater

01 January 1970 9,118 2 View

Irradiation data for JAPAN?

Hi, Could you help me to get the latest (2019, 2020) solar resource data for a particular site in JAPAN? PV GIS and NSRDB data are not in reach to JAPAN, I'm looking for some other database for...

03 March 2021 961 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Help request in CST microwave?

im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...

02 March 2021 2,246 2 View

What thickness need for ITO to use as conductive layer?

I want to do RF sputtering of ITO on glass substrate using magnetron sputtering. what thickness do i need to make it good conductive layer to use it for PSC. Moreover, whats about thickness of...

01 March 2021 395 3 View

Anyone found any research papers on solar furnace design calculations (for solar concentration)?

I am thinking about working on solar furnace with heliostats that concentrate sunlight and heat molten salt, but currently no luck with research. Not a lot of papers based on the subject. (check...

01 March 2021 5,023 5 View

Glass fiber content in a gypsum board ?

Any idea on how to get the volumic ratio of glass fiber in a gypsum board ? Thank you for your help !

01 March 2021 2,501 3 View

What are the harmful effects of these extreme rainfall on the health of newborns? What are the reasons for that?

Extreme rainfall associated with climate change is causing harm to babies in some of the most forgotten places.

01 March 2021 5,647 4 View

How to size battery banks?

I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...

28 February 2021 1,638 3 View

How to design a boost converter for a mppt controller?

I have a doubt on how to select the inductor and capacitor value when I want to implement MPPT controller. This is because we always take a maximum output voltage and current but in this case, we...

28 February 2021 3,637 2 View

Concrete compressive strength databases?

I am looking for datasets similar to this one: http://archive.ics.uci.edu/ml/datasets/Concrete+Compressive+Strength I am looking for concretes with different types of aggregates (Recycled,...

27 February 2021 6,801 3 View