Inside the petrol engine during combustion process how much temperature will be there?

11 November 2016 1 5K Report

Spark plug and other engine casing are made of different materials

since you know the stoichio ratio you can find the amount of energy released during combustion by multiplying the mass of fuel-air mixture with LCV of fuel. From first law of thermodynamic this energy released will be equal to mass of charge * Cv * (Tf _-Ti) where Tf is the final temperature attained by the charge.

Badges
Science topic

More Sathish Dhandapani's questions See All

What is use of PID controller in DC motor?

In mechatronics laboratory in one of the experiment PID is used so can we state that

10 November 2016 9,139 0 View

Can u say the differences between IEEE and IEEE explore?

I have uploaded my paper in international conference they have mentioned that they will publish in IEEE explore

10 November 2016 6,901 6 View

What is the difference between arc welding and gas welding?

basis of properties

10 November 2016 9,691 0 View

What are the parameters to be considered for modelling solar still ?

parameters

10 November 2016 2,739 3 View

Which gas is having low specific head and cost?

Which sheet having high thermal conductivity

09 October 2016 6,761 2 View

How can i determine the efficiency of solar pond theoretically?

Solar pond

09 October 2016 4,944 8 View

Is there any innovation going on for solar pond researches?

Sir, Kindly notify me if there is any things

01 January 1970 2,545 1 View

Is glass or fesnell lens is cost effective for covering solar pond?

Solar pond will be affected by rainfall, wind etc.,

01 January 1970 775 1 View

How to analyze solar pond in ANSYS?

Fabricated with MS sheet with tickness of 2mm ans insulated with HDPE and themocole and salt having concentration of 35mg/litre

01 January 1970 5,857 1 View

Which material is suitable to store temperature in solar air heater?

Solar air heater

01 January 1970 9,263 2 View

I have get this error when i calculated the geometrical optimization for prco3, it takes 12 hours until gives this message in the outputfile?

Fatal error in MPI_Allreduce: Other MPI error, error stack: MPI_Allreduce(1628)......: MPI_Allreduce(sbuf=000002459254A180, rbuf=000002459F86A140, count=4851, MPI_DOUBLE_COMPLEX, MPI_SUM,...

09 August 2024 7,615 1 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

How effective is the Citi Bloc standard basket in enhancing the accuracy and comparability of international construction cost assessments?

Citi BLOC Standard Basket Definitions: A standardized unit representing a fixed basket of construction materials, labor, and equipment costs priced in various cities. Purpose: To create a common...

04 August 2024 8,997 1 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

Can we patent a process flow diagram developed using a process simulator but no actual cases is carried out?

Can we patent a process flow diagram developed using a process simulator but no actual cases is carried out? For example consider a process for certain product manufacture where a new process flow...

31 July 2024 781 1 View

Question about combustion Kinetics ?

I am currently working on modeling FCC catalyst regeneration and have come across a point of uncertainty that I hope you can assist me with. In my previous models, I have utilized lumped kinetics...

30 July 2024 6,137 0 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Can we eliminate the stress singularity at the tip of the crack by manipulating the elastic constants?

The aim of the research here is to prevent the propagation of the crack in the fabricated elastic medium with useful applications.

25 July 2024 9,976 3 View