How to incorporate a variable in damage model?

15 December 2020 7,284 2 View

Question regarding Primer Designing in qPCR?

Hi Everybody I have not done qPCR, and try to figure out the steps of that. From this regard, I am wondering Should primers designed for mRNA sequence or any other (cDNA, DNA, RNA) in qPCR, if...

07 December 2020 2,203 9 View

Mathematical or computational modelling of protein oxidation?

I am looking for a research paper about the mathematical or computational modelling of protein oxidation (caused by reactive oxygen species).. I would really appreciate that if someone helps me...

17 November 2020 2,340 3 View

Is it possible to still allow me to edit my article?

I made two errors in the references when modifying my article proof. Then I immediately informed the journal. But they prepared the article for publication. And published on the journal site.Is it...

16 November 2020 8,273 6 View

Can FEM model learn from experimental results?

I am looking for a research in which the finite element model was trained based on experimental results.

02 October 2020 9,277 19 View

DLS: How to convert Number%,Intensity% and Volume% to q3,q6 or q0 distributions?

Hello, I am using a Malvern ZetaSizer for my work and as a result in this device, it is possible to get PSD based on Intensity%, Number%, and Volume%. My question is how to convert each of these...

14 September 2020 1,399 4 View

How can I access the Seqscape software 2.7 ?

Hi, I need Seqscape software 2.7 to analyze DNA sequences because this version supports 3500 sequencers. Please help me how can I access this version of the software? Thanks

17 August 2020 4,693 3 View

How to extract all key words plus of all publications of an author from web of science?

Its an striking skill for a researcher.

27 July 2020 6,421 2 View

What is the best input signal for training the network and estimating parameters by a neural network?

Hello I want to model and estimate parameters of an aircraft by AI methodology and the input signal has great effect and role in simulation and data collecting. thanks

11 June 2020 3,235 4 View

Why does stresses evolve in only one element in Abaqus explicit?

I am trying to run my VUMAT code with a model in Abaqus/explicit. After that the run has been completed, I observed that the stresses have been evolved in only one element as shown in the attached...

27 May 2020 5,506 3 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Which fluorescent dye to use for measuring total ROS production?

Is DCFDA appropriate for measuring total ROS production, or can it only detect certain types of ROS? If I want to measure total ROS production, which dye should I use?

01 March 2021 9,447 3 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View

Unusually Busy Raman Background?

Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...

15 February 2021 9,922 5 View

Where would? can? positive charge(vacancy) be when grounded?

Hello I plasma(H2N2) treated Al2O3 plate (edge is connected to ground) and wondered if oxygen vacancy migration on the plate can occurs as electrons escape through edge. Or whatever positive...

15 February 2021 8,118 1 View

ZnS oxidizes to ZnO!!why??

when I put my ZnS solution in the chemical bath, the ZnS oxidizes so there are ZnO peaks appearing because of the reaction with the oxygen in the air, despite the fact that I close the beaker...

14 February 2021 5,778 9 View

How to determine the drug loading and the drug release capacity of a polymer micelle using UV spectroscopy?

Currently, I am working on PLA-PEG copolymer micelle for the drug delivery system. I have seen several papers where some researcher talks to centrifuge the drug-loaded micelle to separate the...

13 February 2021 5,822 7 View

How to prepare OH- terminated Si Wafer?

Hi, Folks. I am working on the ALD project to deposit Al2O3 on the Si wafer from TMA and Water. I have struggled with the preparation of OH- terminated Si wafer. I have both Si(1 0 0) and...

08 February 2021 8,792 2 View