Can u guide me some related research articles?
I wanna do High temperature insitu XRD analysis for Ni-FE based super alloy up to 550 deg C. somebody help me where that type of XRD available in India?
09 October 2016 4,217 2 View
I have made a concrete mix with partial replacement of fine aggregates with sludge powder(10-30 percent replacement). I have facing some problems like, Water cement ratio is very high, even i have...
08 September 2016 2,014 3 View
I have made an modified concrete with sewage sludge powder(M35), the partial replacement was done with fine aggregates 5 and 10% only. Water requirements was more W/C (0.47) and superplasticizer...
01 January 1970 880 6 View
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
Require for Rietveld refinement in XRD.
08 August 2024 3,081 2 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View
I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...
06 August 2024 1,367 3 View
During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...
06 August 2024 726 3 View
I want to refine one XRD peak of my in-situ xrd but the background is never working good which ultimately fails the refinement. How to refine and adjust the background using GSAS-II
05 August 2024 5,291 2 View
How to calculate the molar proportions of the oxides from the XRF analyses?
02 August 2024 2,565 2 View
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,789 4 View
Do these peaks in the curve indicate primer dimer or non-specific products?
01 August 2024 7,466 0 View
A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...
01 August 2024 7,051 5 View