Is there any documents or book about how to program on Contiki os?

More Huda A. H. Lubbad's questions See All

Is there a matlab code that perform a data transmission through a wireless sensor network ?

I need the source node to broadcast a message to all nodes in the network. Thanks

11 December 2016 6,583 0 View

How can one simulate a wsn using simulink ?

Is there any paper or document ? Thanks Huda

10 November 2016 4,549 0 View

Which better in WSNs simulation OPNet or MATLAB ?

I want to simulate a wireless sensor network protocol. Include clustering then synchronized flooding to have constructive interference at the sink. I have to choose between matlab and OPNet...

08 September 2016 4,083 5 View

Can anyone help me to get fuzzy logic toolbox of MATLAB?

I would like to write my clustering algorithm for wireless sensor network using MATLAB. I need the fuzzy logic toolbox of MATLAB. Can anyone help me to get a free download toolbox? Thanks

03 April 2015 9,429 9 View

Can anyone help me to get contiki source code for Triggercast?

I need to make a constructive interference at one receiver from multi senders of sensor nodes. I found triggercast is the most accurate technique applied on Contiki Software. However, I didn't...

01 February 2015 8,801 3 View

How do you make time synchronization between WSN nodes to send the same signal at the same time in a real time testbed?

I am working on TI CC2530dk , using Contiki OS. I need two nodes to send the same signal at the same time to the sink. in order that the signals can be added at the receiver. How can I make the...

08 September 2014 6,016 3 View

In Wireless sensor network, how can we determine the ID of each node?

I need all sensor nodes to send the same signal to one node with ID=1. How can we determine which node is of ID=1.Thanks

08 September 2014 3,546 10 View

How can I use timesync.c in my contiki source code ?

I want to synchronize two sender nodes to send the same signal at the same time to one receiver. I use the collect example. how can i use the time synchronization protocol of contiki in my code

08 September 2014 7,599 1 View

I need a reference for calculating PRR or PER in WSNs?

Can anyone provide a reference or document for measuring wireless sensor network reliability using (PRR , or PER calculation) Thanks in advance Huda

01 January 1970 5,712 0 View

Is there any matlab code for PER calculation ?

I need to evaluate the reliability in a WSN by calculating the Packet error rate (PER) and PRR (Packet reception rate) using MATLAB Do anyone have a matlab code to calculate PER or PRR , or...

01 January 1970 4,747 0 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

How to solve g_mmpbsa error?

Program: g_mmpbsa, version 2024.1 Source file: extrn_apbs.cxx (line 152) Fatal error: Failed to execute command: $APBS pybYcUWA.in --output-file=pybYcUW.out

07 August 2024 6,066 0 View

How to convert a privately loaded document into a public document?

I attempted to make a privately uploaded text public but a window appeared that said an error occurred. There was no explanation provided as to why there was an error or what might be done to...

05 August 2024 8,025 7 View

Do you know any references for analyzing stochastic fiber orientaion composites ?

Hello everyone I am looking for one or some books for propertes and behaviors of stochastic fibre orientation composites. unfotunately I could not find any suitable reference for thias by...

04 August 2024 3,461 3 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

Are you interested in contributing a book chapter on biomaterials in Orthopaedics?

I am editing a book for Springer Nature on recent advancements and future trends in biomaterials for orthopedic and trauma applications, with a publication date slated for early next year. If you...

29 July 2024 5,015 9 View

After a lot of feature engineering for CTR modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing?

After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?

29 July 2024 4,955 0 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

Are students in the MBA program in Fisheries Enterprises Management eligible to work in the aquaculture industry abroad?

Are students in the MBA program in Fisheries Enterprises Management eligible to work in the aquaculture industry abroad? Could you explain the foreign countries interested in recruiting...

28 July 2024 8,378 2 View

How can we calculate the percentage of configuration interaction (CI) in the UV output data of the Gaussian program?

How can we calculate the percentage of configuration interaction (CI) in the UV output data of the Gaussian program? for example: Excited State 17: Singlet-A 5.1359 eV 241.41 nm...

28 July 2024 9,165 2 View

Vahid Maleki Raee

There are bunch of resources available online. These are some of many. Hope they give u some guidelines. The first 2 are two articles

https://www.sics.se/~thiemo/seniot09cccc-notes.pdf

http://www.dunkels.com/adam/dunkels04contiki.pdf

http://www.qazimamoon.com/2013/06/basic-tutorial-for-programming-in_12.html

http://www.contiki-os.org/

https://github.com/contiki-os/contiki/wiki/Code-Contributions

http://contiki-os.blogspot.com/

Huda A. H. Lubbad

Thanks alot Vahid