Huda A. H. Lubbad

11 Questions 15 Answers 0 Followers

Questions related from Huda A. H. Lubbad

Is there a matlab code that perform a data transmission through a wireless sensor network ?

I need the source node to broadcast a message to all nodes in the network. Thanks

12 December 2016 6,560 0 View

How can one simulate a wsn using simulink ?

Is there any paper or document ? Thanks Huda

11 November 2016 4,518 0 View

Which better in WSNs simulation OPNet or MATLAB ?

I want to simulate a wireless sensor network protocol. Include clustering then synchronized flooding to have constructive interference at the sink. I have to choose between matlab and OPNet...

09 September 2016 4,058 5 View

Is there any documents or book about how to program on Contiki os?

Can any one provide me with online documents or book about Contiki operating system.

05 May 2015 6,877 2 View

Can anyone help me to get fuzzy logic toolbox of MATLAB?

I would like to write my clustering algorithm for wireless sensor network using MATLAB. I need the fuzzy logic toolbox of MATLAB. Can anyone help me to get a free download toolbox? Thanks

04 April 2015 9,400 9 View

Can anyone help me to get contiki source code for Triggercast?

I need to make a constructive interference at one receiver from multi senders of sensor nodes. I found triggercast is the most accurate technique applied on Contiki Software. However, I didn't...

02 February 2015 8,775 3 View

How do you make time synchronization between WSN nodes to send the same signal at the same time in a real time testbed?

I am working on TI CC2530dk , using Contiki OS. I need two nodes to send the same signal at the same time to the sink. in order that the signals can be added at the receiver. How can I make the...

09 September 2014 5,987 3 View

In Wireless sensor network, how can we determine the ID of each node?

I need all sensor nodes to send the same signal to one node with ID=1. How can we determine which node is of ID=1.Thanks

09 September 2014 3,520 10 View

How can I use timesync.c in my contiki source code ?

I want to synchronize two sender nodes to send the same signal at the same time to one receiver. I use the collect example. how can i use the time synchronization protocol of contiki in my code

09 September 2014 7,571 1 View

Is there any matlab code for PER calculation ?

I need to evaluate the reliability in a WSN by calculating the Packet error rate (PER) and PRR (Packet reception rate) using MATLAB Do anyone have a matlab code to calculate PER or PRR , or...

01 January 1970 4,714 0 View

I need a reference for calculating PRR or PER in WSNs?

Can anyone provide a reference or document for measuring wireless sensor network reliability using (PRR , or PER calculation) Thanks in advance Huda

01 January 1970 5,684 0 View