Comparison of CBD by water bath is better or the method of deposition by thermal chemical spray
interested
Thank you dr.Nada for your answer
Dear research community. I want to study FTIR spectra of Immobilized enzyme on alginate beads before and after biodegradation, do i need to grind the Immobilized enzyme on alginate beads for the...
26 October 2020 8,606 1 View
Looking for this.
20 April 2020 7,588 3 View
Dear Linguists, I need a help regarding my dissertation relating to the search of 4-word clusters on software antconc, I am using the following model of Hyland Noun phrase + of the end of the...
14 March 2020 1,861 3 View
What are performance indicators in interoperable trust model of IoT systems?
19 May 2019 4,232 1 View
if there is so then it may be good alternative material to electric Wires.
17 November 2018 1,356 2 View
My sample is an LFP precursor wherein calcination requires inert / nitrogen gas to form LFP. The problem is, in Indonesia I have not found a place to test DSC TGA with nitrogen / inert gas flow....
28 October 2018 9,352 4 View
Honybee nest was found to have a negative effect on the archaeological sites e.g. affect the colors. we are trying to study the chemical composition of honey nest which could have this effect....
09 October 2018 9,922 0 View
i have two different solid plant extract ethanol and water to check antiepileptic activity which is the best saline to dissolve the solid plant extract to i.p in mouse. thanks & regards...
03 April 2018 543 3 View
machine learning
24 February 2018 4,087 4 View
I am testing enzyme inhibitory activity of nanoparticles but surprisingly the enzyme inhibition is decreasing with increasing concentrations of nanoparticles. Why is it so?
06 February 2018 1,785 5 View
03 March 2021 8,272 1 View
In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?
01 March 2021 1,923 3 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
Hi all The question is related to TGA(Thermogravimetric analysis). Thermal degradation easily understood but why do samples weight decrease? altough just binding is broked, the weight of...
26 February 2021 1,100 5 View
Hi, my question is about the heating of thermal cycler machines and I hope some of you had experienced a similar thing previously. There are two thermal cycler machines in the lab(BioRad) and for...
26 February 2021 4,777 4 View
I am working with Polyacrylic acid (100.000Da) and instead of water, I need to use another solvent (dioxane) to dissolve PAA. However, because of the high molecular weight, it's quite hard to...
25 February 2021 2,225 5 View
I have radial blade centrifugal fan design which will be mounted on exhaust side of electric traction motor. The fan will be mounted on same motor shaft inside the housing. How can I verify that...
23 February 2021 2,390 3 View
I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...
23 February 2021 4,155 4 View
23 February 2021 9,253 1 View
I have prepared Ag-Cu alloy with polymer coating upon it.... how can I measure thermal conductivity of it ?
22 February 2021 5,915 3 View