Is it possible to simulate a cable-driven parallel robot in ADAMS?
We have tried, and there will be a strange solution error frequently.
Thanks!
I have to interprete a kind of LTO samples with structure spinel in X-ray diffraction analysis but I don't know how I can get Miller indices. Thank you
11 February 2020 6,110 3 View
I want to try different methodologies to grow spirulina in a 1 cubic meter tank and compare the production yield. Please if you have a tip, let me know.
13 September 2019 1,583 3 View
I have tried to detect phospho-MLKL in a Western Blot using the positive control cells L929 treated with 100 ng/ml TNF alpha, 100 nM Smac mimetic and 30 uM Z-VAD for 6h and then...
03 April 2018 5,697 1 View
I have found a few researches, but I'm not sure about key words, so I'm afraid of not finding texts..
14 March 2016 6,335 13 View
01 February 2016 6,121 4 View
I worked with a graduate student who did some research, participated in discussion, and collected data. He wrote some short pieces of the paper. Since the he graduated and his parts of the work...
04 May 2012 2,091 4 View
Hi dears. Do you know a good journal finder for papers?
01 January 1970 4,474 92 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...
28 February 2021 2,116 1 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...
24 February 2021 1,598 2 View
Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...
23 February 2021 1,761 1 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View
For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...
21 February 2021 7,624 3 View
Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...
21 February 2021 2,333 4 View