Is it possible to measure the acidity of MOFs?

More Venkatesha N J's questions See All

Ti6Al4V - Phase differentiation between alpha and alpha prime martensite?

Dear Researchers, Is it feasible to distinguish between alpha and alpha prime martensite in the Ti6Al4V alloy under rapid solidification in the as-cast state using XRD, in addition to...

30 July 2024 3,849 0 View

Dear researchers. pl help how to plot jablonski energy level graph and magnetic hysteresis curve in origin?

through origin software

17 July 2024 4,991 0 View

Subculturing of colletotrichum capsici is not able to do please help me?

Hello all, i am working on Chilly anthracnose disease and the pathogen involved is colletotrichum capsici but the problem is occuring while subculturing, i can isolate pathogen from chilly fruit...

17 July 2024 1,610 2 View

What is the minimun number of studies for each subgroup analysis in meta-analysis?

Hello everyone, I am conducting a meta-analysis to find if x has superior effect than y on the outcome. I used the SMD method and I got a significant moderate heterogeneity of a value I2:...

09 June 2024 8,446 3 View

How to make pre-post data analysis more 'sophisticated' than a paired samples t-test?

As part of my thesis I'll be conducting a single-sample pre-post intervention analysis, in which my only DV is ordinal (7-point Likert scale). In my research proposal I said that I would use...

05 June 2024 3,122 2 View

Is the "snowball metrics" mathematically well-founded?

Snowball metrics is used by scival.com to report some performance indicators. This metrics seems rather obscure from the mathematical standpoint. Unfortunately there is apparently (after a quick...

05 June 2024 7,463 0 View

Effect size to check if x is superior than y... How to calculate it? within or between?

Hello everyone, I am conducting a systematic review to see if treatment x is superior in its effect than treatment y. Since most the studies I found did not report interaction effect, I was...

24 May 2024 6,130 2 View

What are recent UWB Antennas ?

I require recent UWB antennas manufactured

15 May 2024 3,888 1 View

How to deal with zero/negative growth rates in tree growth models?

Tree growth is an important aspect of forestry and forest ecology. Typically a growth rate is calculated as the difference between two stem diameter measurements over a given time interval: (dbh2...

15 May 2024 8,739 2 View

How can technology help hospitalized children?

How do you think technology can help hospitalized children?

10 May 2024 950 2 View

• What the possible Persistent Organic Pollutants and Heavy metals present in fluorspar, sediments, and water bodies around its mining area?

Approximate concentrations are require in compared with the WHO permissible limts

11 August 2024 2,723 1 View

Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,444 7 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

How to convert g/kg Humic acid dose to kg/ha?

I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?

02 August 2024 7,186 6 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

Simulation of metal drawing by Abaqus with UMAT?

Hello, colleagues. Recently, I have been working on a metal processing simulation with my UMAT in Abaqus. I have outlined the corresponding simulation, but I keep encountering issues that cause...

30 July 2024 7,062 1 View

How to make the concentration measurements for the hydrogen absorption/desorption in the metal hydride?

Hello Everyone! I am trying to create a metal hydride system where I am trying to create a temperature control with the emphasis on measuring the concentration of the hydrogen with the hydrogen...

29 July 2024 7,577 2 View

How to make Boehm titration ?

Hello Everyone, While doing Boehm titration, We use nahco3 in order to determine carboxylic acids. Then the mixture was agitated. After a while, the solution was filtred and HCl was added. After a...

29 July 2024 4,048 4 View

Vijaykumar Marakatti

yaaa its possible by all these techniques ! Call me

I will discuss the things....

Timur Islamoglu

A versatile alternative to TPD method would be potentiometric titration to determine the pKa of the different sites in a MOF. Note that MOF needs to survive in aqueous electrolyte. Please see the reference below.

http://pubs.rsc.org/en/Content/ArticleLanding/2016/TA/c5ta07687k#!divAbstract