loss on drying vs water content in potasssium carbonate
I got these smeared bands quite often lately. We typically run the gel at 140V with a 10-12% gel and do a wet transfer at 220 mA for 1.5 hr in cold room. We also noticed some dirty spots/dots (see...
10 August 2024 7,480 3 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
The threshold voltage (Vth) of a MOS device plays a crucial role for its operation. At the same time, noise is an intrinsic factor. So how noise (flicker or thermal) change with the change in...
29 July 2024 3,246 0 View
In a research, lesion diameter due to a disease has a CV below 10%. However, in an another parameter, disease inhibition percentage (compared to control), a value derived from lesion diameter...
27 July 2024 201 0 View
If you don't understand my question let me know
21 July 2024 563 1 View
I am working on scale development in behavioral finance by undertaking a mixed-method approach using the exploratory sequential design. The phenomenon has diverse meanings in existing literature...
20 July 2024 9,153 11 View
I need to convert Available phosphorus into total phosphorus
18 July 2024 6,799 3 View
Bioinformatics tools like peptide cutter
15 July 2024 6,453 1 View
The burden of obesity is enormous. The greater challenge lies in accurately diagnosing obesity at the right time, reflecting the true increase in visceral fat. BMI may not accurately represent...
14 July 2024 8,771 4 View
How does high humidity affect the growth and development of crops?
10 July 2024 7,258 20 View
Hi researchers! I'm working on soil texture analysis, and the end result for sand is doubtful because there is black sediment appearing after drying, as shown in the figure. Is it considered sand?...
30 July 2024 557 2 View
I am doing research on wear mechanism of the additive manufactured metal parts under dry condition. Please share the reference to start the analytical modelling of the wear prediction.
29 July 2024 6,115 0 View
Hello, I am currently working with Malaria Pf/Pan nitrocellulose membranes coated for malaria detection. After drying the coated membranes in an Incubator (overnight at 37°C), I've noticed that...
16 July 2024 7,937 1 View
I have conducted a survey on the "effect of vacuum drying conditions on carbohydrate content of angelica.S". The result show that, when increasing the vacuum degree, the carbohydrate content first...
13 July 2024 592 1 View
Hello, I am trying to convert to convert ppm of a solution to μmoles/g of dry sample.
09 July 2024 7,081 1 View
what is the protocol for enzyme freeze drying?
09 July 2024 6,464 6 View
Hello! I am planning to collect plant leaf samples for stable isotope analysis. I will be collecting them from the field and storing fresh tissue on ice. I have heard that bringing along a food...
01 July 2024 9,125 1 View
1- Please provide information about the chemical composition of curing agent for PDMS(Sylgard 184 Kit)? 2- what dry solid percentage is obtained for a ratio of 10 to 1(PDMS to hardener)?
30 June 2024 6,814 2 View
Dear colleagues, I would be grateful to anyone who can answer my two questions: 1. Do the proportions of the shark's body change after drying? In other words, is it possible to discriminate two...
30 June 2024 6,101 3 View
In other words, I did not use the trained XGBoost model to make predictions on the test set and then use SHAP for interpretation. The reasons are as follows: Even with the best and most...
26 June 2024 7,332 1 View