According to β method MPPT, β is given by the following formula
β=ln(Ipv/Vpv)-c*Vpv=ln(I0*c) where I0 = reverse saturation current, c=diode constant given by C=q/(k*T* η *Ns)
q=electronic charge ,η= ideality factor, k=Boltzmann constant,
T= temperature in Kelvin and Ns =number of series connected
cells, respectively. But according to flow chard we are sensing Ipv and Vpv , since c is function of T so do i need to sense T also ? ( considering case where T is changing over the time along with irradiance).
The initial inspection of the beta equation shows the dependency on the temperature; however, the changes of the beta values at various MPPs are very small. Therefore, there is no need for continuous measurement of the temperature. You may refer to,
De Brito MA, Sampaio LP, Junior LG, Canesin CA. Evaluation of MPPT techniques for photovoltaic applications. InIndustrial Electronics (ISIE), 2011 IEEE International Symposium on 2011 Jun 27 (pp. 1039-1044). IEEE.
maximum power point tracking MPPT based on the measurement of temperature and short-circuit current
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Energy
- Energy-Generating Resources
- Renewable Energy