In latent profile analysis, how to draw a boxplot using standardized means?

Kang Ma @Kang-Ma-5

01 October 2023 0 6K Report

hi i would like to draw a boxplot for the latent profile in LPA instead of curve lines and thx for the advice

Badges
Science method

More Kang Ma's questions See All

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 978 5 View

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Hello everyone！ I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...

05 August 2024 5,727 2 View

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...

03 August 2024 5,357 0 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,225 1 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 588 4 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,232 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 904 2 View

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...

29 July 2024 7,196 9 View

How to draw the five chelate rings of [Co(EDTA)]- on this picture?

Is this circle one of the rings?

03 August 2024 5,986 0 View

How to make overlapping p-h diagram in EES?

I want to draw ph diagram using Engineering equation solver EES for refrigerant R134a and R1234fy and some other. I don't know how to draw the multiple ph diagram on same dome or overlapping to...

30 July 2024 647 7 View

How to draw photon-magnon coupling color plot in origin?

Please help me in plotting the photon-magnon coupling plot as shown below

14 July 2024 1,632 1 View

The criterion about maximally localized wannier function?

I heard that as the value of "num_iter(tag in wannier 90)" is higher, spread of Wannier function(=WF) is gradually lower in wannier 90. If so, is this procedure that minimize the spread of WF...

13 July 2024 4,608 0 View

Taking a cut line through deck build in silvaco?

Hi everyone hope your all doing good. I’ve been looping my scripts and am trying to take a cut line of the conduction band energy with respect to y for each loop. Basically, I want to take a...

03 July 2024 9,133 1 View

Is there a thin line between cultural and ethnic entrepreneurship?

My feeling is that there is - but where does one draw distinction.

01 July 2024 3,716 4 View

What is initial intensity in Stern-Volmer plot for quenching studies in solution state?

I was performing quenching studies in solution state. While plotting the Stern-Volmer graph, which intensity should I use as initial intensity (I0). For example, I take 1 ml of 0.1 M fluorophore...

25 June 2024 5,385 1 View

Could anyone recommend software for drawing the physical structure of nanoparticles?

I am looking for professional software to draw the physical structure of nanoparticles or vesicles, not the chemical structures for which we use ChemDraw, but the actual physical structures,...

23 June 2024 1,291 3 View

Drawing fullerene more than 60 carbon?

I have ChemDraw 22.2.0 and I want to draw PC70BM but I just found C60 and less in the templates so, any one can help me ?

18 June 2024 3,098 3 View

What is the size effect of this nanoparticle for flourescence sensing of heavy metals?

Hi, I am working on the flourescence sensing of heavy metal ions in aqeous media using chalcogenide nanoparticles. If I dope a metal ion into this nanoparticles by reducing the moles of already...

11 June 2024 5,567 2 View