What is the best and most used ccl4 concentration to induce mice acute liver injury ??

Hello !!! I am working on the hepatoprotective effect of some medicinal plants and, i want to use the ccl4 induced acute liver injury ( 7days protocole) there are a plenty of articles that treat...

26 December 2017 1,186 4 View

Any advice on a Folin ciocalteu assay problem ?

i used the folin ciocalteu assay to determine the TFC ( total phenolic content)using the Singleton and Rossi method cited in wong and al 2006.i got different shade of blue color from an extract to...

27 December 2015 7,585 14 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View

PMSM Inter Turn Short Circuit fault, Dataset?

Hi, I'm looking for a dataset of a PMSM with an inter turn short circuit fault. Does anyone know a dataset which is available?

21 February 2021 5,663 2 View

What is the damping coefficient of Well's/impulse turbine that may be introduced into a mechanical oscillation model to simulate the PTO damping?

In tank experiments, it is easy to simulate the PTO damping by the use of orifices, however in modeling full scale and real conditions the trurbine damping coefficient must be added to the water...

31 January 2021 7,325 1 View

Calculate the Strain at a Node in the Turbine Blade FE Model?

Hello Team, I would like to calculate the strain at a node #5 in a direction (l1,m1,n1) in the turbine blade FE model as shown. This node is connected with four elelemnts (#1,#2,#3,#4) and I have...

11 January 2021 7,702 3 View

Need help in designing a countour which create a seperation bubble on a flat plate ?

Hi This is Ravi. i am trying to create a separation bubble on a flat plate using a contoured upper wall. I want to apply same pressure distribution of a given blade on the flat plate. I have read...

21 October 2020 6,635 5 View

What pressures should I choose in a reheated rankine cycle?

09 October 2020 9,117 4 View

Query Regrading Blade design on Modelling software?

Anyone can Guide me how to do blade design of the Kaplan Turbine using Velocity diagram on PTC creo or any modelling software

06 September 2020 6,161 2 View

How can i calculate Cp ( Coefficient of power) in Vertical axis turbine?

I have a question on Cp in the wind turbine. I have calculated the moment in the z-axis as my rotor also rotors along the z-axis. I got the moment values from my simulation. I applied the...

23 July 2020 5,622 4 View

Are move probabilities used during MCTS procedure in AlphaGo Zero?

In AlphaGo Zero algorithm, the neural network returns a pair (p, v) consiting of a vector of move probabilities p and a scalar v indicating winning probability. The v is used for node evaluation...

06 June 2020 5,588 3 View

Can discretization method change non-observable system to became an observable one?

Is it theoretically possible, that after discretization by using Talyor Series Expansion, a non-observable nonlinear system will became an observable? It was proved, that used continuous model of...

15 May 2020 3,608 5 View