Hi Thank you for your reply I use the DIgSILENT Power Factory software.

I find a useful link

http://fglongatt.org/OLD/Tutorial_DigSilent_EN.html

To solve this problem you must set the initial values of the DFIGs as the same and the grid transformer must match the DFIG terminal voltage. I did this simulation in the PSCAD package software. This problem is not difficult you solved it easy just check all the DFIG data, transformer and transmission line. Furthermore, it is important to check the DFIG converter control circuit.

Hi Thank you for your reply I use the DIgSILENT Power Factory software.

I find a useful link

http://fglongatt.org/OLD/Tutorial_DigSilent_EN.html

hi

http://fglongatt.org/OLD/Tutorial_DigSilent_EN.html