How to measure the Seebeck coefficient and the thermal conductivity of thin films?

How to measure the Seebeck coefficient and the thermal conductivity of thin films deposited on the ITO substrate. the thicknesses of the thin films are between 200 and 500 nm.

01 February 2020 7,360 6 View

What is the control for cell cycle assay?

What is the nature of sample that we use it to detect the area for each phase in histogram of cell cycle assay?

10 November 2018 8,780 4 View

Is it fine having a plagiarism from my previous researches, as the new research is a complementary of the information presented in the previous paper?

Dear researchers.. I would like to present a research paper which complementary work for my previous research, and I found the similarity ratio about 30% and about 22% from the previous research....

06 July 2018 1,160 16 View

Did anyone have experience with cell stimulation in cell culture?

I am going to stimulate fibroblast-like synoviocytes by leptin and TL1A to study the expression of IHH gene. I have wondered, maybe there are special protocols or instructions to follow them in...

04 May 2017 9,070 1 View

What is the relation between the number of people and the temperature in the room?

05 June 2016 8,300 8 View

Buffer Exchange using column packed with sephadex G-25 effect on protein concentration?

Hello, If i am doing a buffer exchange for an antibody of 1mg/mL, does the elution lose protein in the process of buffer exchange? For example, if i flow through 500 uL of 1mg/mL sample, and...

03 March 2021 6,299 3 View

No title

03 March 2021 5,360 2 View

Help request in CST microwave?

im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...

02 March 2021 2,246 2 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

What is the best way to calculate the angles of twist for concrete columns subjected to torsional moment using finite element software?

In Finite element software like ANSYS , there is difficulty in obtaining direct results of twisting of concrete members because SOLID65 which is the unique element designed to represent concrete...

26 February 2021 3,806 2 View

Compute for the total volume of concrete needed for the concrete pouring of the foundation including its column up to NGL only as shown in the plan?

Looking for the quantity of cement, sand, and gravel of footings and columns. Thank you!

25 February 2021 3,092 2 View

No amplification data for qPCR on MxPro?

I have set up a qPCR run on MxPro with SYBR green and ROX as a reference, however, when I go to the analysis section the program seems to only collect data for the dissociation curves and not the...

25 February 2021 8,039 1 View

Can I use TCA instead of TFA for protein analyis in RP-HPLC?

I am trying to analyze lipase using the reverse phase-HPLC C18 column. In the literature, 0.1 % TFA was and 60% ACN was used. Can I use TCA in place of TFA? If any other methods are available to...

25 February 2021 2,388 3 View

Can I use acetic acid with an ELITE WAX Perkin Elmer column for Gas Chromatography?

Hi! I would want to know if I can use acetic acid with an ELITE WAX Perkin Elmer column for Gas Chromatography. This column has a polyethylene glycol phase, but I can't find the manual to check...

22 February 2021 730 2 View

My silica gel column dried can I somehoe save the trapped matter?

I tried to separate my substance from a protein in a sillica gel column. By mistake, it dried and cracked. Can I save the trapped substance? Can I repack it ,or at least elute all of the trapped...

22 February 2021 1,789 3 View