D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What is the outcome of research for researchers?

For the past few years I have been in doubt and a question about the nature of research always occupies a part of my mind. As researchers, we have been asking and researching for years. We may...

17 November 2020 4,505 11 View

Does mesh refinement affect modal analysis in ANSYS?

Hi, I have done a tutorial by SimCafe Cornell namely Modal Analysis of 3d NACA 0012 Airfoil using ANSYS. I have observed that Frequencies of vibration and their respective mass participations do...

04 October 2020 7,221 3 View

How i can get rid of phenolic contamination (low 260/230 ratio) in RNA extraction from blood by using Gene All TRIZOL (Ribo LS)??

in this work i use the standard protocol in extraction& good sampling and use chloroform and twice wash with ethanol 75% but i have phenol contamination (low 260/230 ratio) for example: OD:...

21 September 2020 8,408 3 View

How staad pro analyze Response spectra problem?

I am modelling a steel structure problem in STAAD Pro. I want to check behaviour of that steel structure against Response Spectrum. I have facing challenges in understanding of how STAAD Pro...

08 July 2020 1,093 1 View

How to add plate above the beam in STAAD Pro?

I have facing problem in analyzing a steel structure that has steel plates above and below the steel beam. Is there any way to add plates? I have added plates at center but that decreases moment...

08 July 2020 1,697 1 View

How can I find some material (books, articles and etc.) to do and write a systematic literature review(SLR)?

I need to review theories of moral decision making in a systematic method to find different definitions and models of that. I have read some guidelines about the systematic review and...

30 June 2020 3,087 13 View

For qualitative study, should we have separate results and discussion section or clubbed under "results and discussion"?

Can someone share the relevant papers (results and discussion separately written) in which the author(s) used thematic analysis?. Thanks in advance. Cheers

07 June 2020 6,450 1 View

Is there any labeled public dataset for COVID-19 ?

Hi, do you know any resource for accessing data-sets about the symptoms and conditions of people who tested positive or negative for the Corona virus ?

03 March 2020 508 6 View

How to calculate total energy consumption of an industrial sector using specific energy consumption values?

Dear community, Currently, I'm working on energy modeling of the foundry sector in Pakistan and I'm facing difficulty in calculating the total energy consumption of the sector while having...

06 February 2020 1,072 2 View

How optimize the Size Exclusion Chromatography?

Hello! I'll do a size exclusion chromatography, but I only have an open column, and I'll perform the peptide extraction from yeast, using buffer lysis (sodium phosphate 50 mM/NaCl 30 mM/DNAse and...

01 March 2021 2,215 2 View

No title

01 March 2021 3,905 5 View

What test should I use to compare two or three means, if data is not normally distributed but sample size is > 30 in each group?

I personally feel this as a most confusing question. As per my understanding, if sample size is > 30, and sample is skewed, we can still use paramteric approach, as it will follow Z...

01 March 2021 1,587 6 View

Is it necessary to report effect size (ES) in statistics of biomedical research given that we already report p values routinely?

Pls share your thoughts

01 March 2021 7,330 4 View

How to model Supercritical water gasification (SCWG) process in Homer software?

Hi everyone How to model Supercritical water gasification (SCWG) process in Homer software?

25 February 2021 4,075 1 View

Why there are two peaks while using the mie plot of Silver nanoparticle?

Hi, I am trying to learn the theoretical modelling of silver nanoparticle using the Mie scattering theory. After that, I discovered a software named Mieplot developed by Philip Laven, where it...

25 February 2021 7,493 6 View

How to calculate Z (the number of molecules in a unit cell) for calculating theoretical density?

I am trying to calculate the theoretical density of my ceramics materials. I use the formula below to calculate the theoretical density: Theoretical density = (Molecular weight x No. of molecules...

24 February 2021 3,823 2 View

How to handle studies which report perfect effect sizes in a meta-analysis using Pearson's r?

I'm in the process of updating a meta-analysis and in one of the new studies, effect sizes are reported as Tau-U. Two of the effect sizes are reported as Tau-U = 1.00. I am using Andy Field's...

24 February 2021 2,265 3 View

Sample size determination for non-parametric tests?

How do I run a a priori sample size determination for non-parametric tests, like the Mann-Whitney U-test and the Kruskall-Wallis or other non-parametric tests that accord with the unpaired t-test...

24 February 2021 166 6 View

How to determine a priori sample size for t-test with unequal means?

I need to conduct a a priori sample size determinations for t-test with unequal means, but I don't know the sizes of the groups nor the ratio of both groups... Can I do a sample size determination...

24 February 2021 8,289 3 View