Howdowe find during charging and discharging Phase Transformation on Lithium rich layered oxide?

05 December 2017 0 374 Report

How do can I qualitatively identify the Phase transformation on Lithium rich layered oxide while charging and discharging ?

Is it possible by doing GITT can we found phase transformation?

Badges
Science topic

More Vasu Shanmugam's questions See All

What does the disappearance of the XRD peak near 8 degrees, corresponding to the (002) plane of MXene, imply in a MXene-based nanocomposite?

I am trying to synthesize Mxene based nanocomposites. Interestingly, the characteritic peak dissapears which indicates the disruption in interlayer spacing of MXene. So, what might be other...

03 July 2024 5,702 3 View

How to prepare polyaniline emeraldine salt ( PANI -ES) sample for Transmission electron microscope (TEM) analysis?

I need to do TEM analysis for my Polyaniline emeraldine salt form. May I know which solvent is appropriate for preparing TEM sample?

25 June 2024 9,086 3 View

How to attach GAAFET library to cadence tool?

I want to know how to attach the Gate all around FET library can be 3nm to cadence tool. Where we can get the 3nm GAAFET Library.

17 April 2024 2,627 0 View

Getting idle1.2.2 error in autodock1.5.6 how to figure out ?

hello, i am getting idle1.2.2 error in autodock1.5.6. to open my pdb 1j5e file, file is not even visualized on my screen. so i am getting error in first step of docking. please give...

30 January 2024 7,854 3 View

Can u send me the full paper ?

Green and recyclable mesoporous silica supported WO 3 –ZrO 2...

17 January 2024 9,868 0 View

Can anyone suggest some Professors who are working on biosensors in French Universities?

I am trying for a summer internship at French universities. But I finding it dificult to find relevant professors. Any help with this is highly appreciated.

16 January 2024 4,625 0 View

Which is best solvent for polyaniline emeraldine solvent (PANI-ES) for spin coating on ITO substrate?

I have synthesized Polyaniline via chemical oxidative polymerization. I need to prepare a thin film of the same by using spin coating. But I am not sure which solvent to proceed with. Any imsights...

11 January 2024 4,042 11 View

How to measure zeta potential of isolated plasmid dna ?

I am working on Condensation of plasmid DNA(pDNA) by using PEI passivated Carbon dots (CDs). To verify whether PEI-CD is complexing , I am measuring zeta potential of pDNA-CD complex. But the...

29 November 2023 9,633 4 View

How to calculate the hydrolysis ratio in polyol process?

I am trying to synthesize cobalt ferrite via polyol process. Many authors have reported the role of hydrolysis ratio (water/metal molar ratio) in size and other crucial properties of the cobalt...

18 September 2023 5,098 0 View

Is it mandatory to maintain inert atmosphere for Poly3-hexylthiophene (P3HT) synthesis through oxidative coupling using ferric chloride as catalyst ?

I am synthesizing P3HT by oxidative polymerization of 3-Hexylthiophene by using FeCl3 as catalyst. While going through the relevant literature, I came to know that polymerization has to be...

12 September 2023 5,016 1 View

Problems about acousto-optic coupling in Comsol, how to check whether the moving mesh is correct?

I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...

13 August 2024 9,795 0 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

Why aren't most metal oxides insoluble in water?

Why BaO (s) + H2O(l) ---> Ba 2+(aq) + 2 OH - (aq) if Oxygen loves owning all the electrons, why would it bind to hydrogen which competes with Oxygen for electron ownership more so than...

03 August 2024 5,392 1 View

Why chloride turns into chlorine gas in a Downs cell?

I imagine the battery drives the graphite into a carbocation, then chloride is oxidized to donate the electron to the carbocation, but what pushes the lost electrons of chloride to be shared...

03 August 2024 5,384 0 View

How to calculate the molar proportions of the oxides from the XRF analyses?

02 August 2024 2,565 2 View

What is the solubility of Iron (+3) in Bismuth Oxide?

Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco

29 July 2024 2,163 1 View

Addition of EDTA during the synthesis of copper nanoparticles to prevent it from being oxidized?

I've attempted to use this method to synthesize copper nanoparticles. Copper nanoparticles can be synthesised using a variety of precursor materials. CuSO4, distilled water, NaOH, and EDTA are...

28 July 2024 8,027 3 View

Will the catalytic effect of retained austenite happens in steels including RA?

The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...

27 July 2024 8,508 0 View

Standard curve of H2O2?

Hi, I need to prepare a standard curve of H2O2 to evaluate the primary products of oxidation. H2O2 I have is 35%. How do I prepare a stock of H2O2 10 microlitere. If s.o has experience, I would be...

26 July 2024 3,460 2 View

Non -oxidizing metal binders?

I'm trying to sinter some Nb parts and I'm trying to find a binder which does not produce oxidative compounds when it decomposes.

25 July 2024 9,823 3 View