How will you measure the "Well Flowing Bottom-Hole Pressure" using the Permanent Downhole Gauge (PDG) in a typical CBM Reservoir?

Suresh Kumar Govindarajan @Suresh_Kumar_Govindarajan

05 May 2018 0 2K Report

How will you measure the "Well Flowing Bottom-Hole Pressure" using the Permanent Downhole Gauge (PDG) in a typical CBM Reservoir? Do they still lead to production loss due to shut-in periods?

Badges
Science topic

Similar topics
Thermodynamics
Pressure

More Suresh Kumar Govindarajan's questions See All

Can Gas Hydrates (a Green House Gas) quicken the Climate Change?

Can Gas Hydrates (a Green House Gas) quicken the Climate Change (Warming)?

10 November 2018 7,297 18 View

Whether NUMERICAL MODELS have really become the ARTIFACTs of inversion of field data to estimate hydraulic parameters?

Whether NUMERICAL MODELS have really become the ARTIFACTs of inversion of field data to estimate hydraulic parameters in the context of modeling fluid flow through porous media?

10 November 2018 2,445 3 View

How does Darcy’s law accommodate two different scales in the same empirical relation?

Consideration of fluid pressure at the pore-scale, while considering the fluid velocity (Darcy flux) as an average over the Representative Elementary Volume in the same Darcy’s law. How does...

10 November 2018 4,159 13 View

El-Nino and North-East Monsoon in Peninsular INDIA: What is the actual physics that relates these two?

El-Nino and North-East Monsoon in Peninsular INDIA: What is the actual physics that relates these two? An analysis of the spatial distribution of the composite rainfall for El-Nino (La-Nina)...

09 October 2018 1,271 0 View

If initial waters mix and react, interpretion of net geo-chemical mass-balance reactions between initial and final water along a flow path feasible?

If the initial waters mix and subsequently react, whether - Can we interpret net geo-chemical mass-balance reactions between an initial and final water along a flow path?

09 October 2018 2,852 0 View

Pore Scale Modeling (PSM) for describing fluid flow through porous medium: Is it significantly different from Darcy’s macroscopic-scale modelling?

Pore Scale Modeling (PSM) for describing fluid flow through porous medium: Is it significantly different from Darcy’s macroscopic-scale modelling? Variations of fluid velocity and pore-geometry...

09 October 2018 2,337 3 View

Addressing the term "nano-Darcy": Does it make sense?

Darcy - by itself - refers to a porous system at the macroscopic scale; and it emphasizes strongly that we are NOT supposed to look at the details - even - at the microscopic-scale. Given this...

08 September 2018 4,383 1 View

Diffusivity equation for describing oil flow in a petroleum reservoir: Can it be assumed to be an incompressible fluid?

Diffusivity equation for describing oil flow through a petroleum reservoir is deduced by coupling mass and momentum conservation equations. In many cases, the oil flow within the reservoir is...

08 September 2018 8,340 0 View

The "permeability-loss" and the "permeability-gain" in a typical CBM reservoir - nearly have equal magnitudes?

The "permeability-loss" term is associated with pressure depletion, while the "permeability-gain" is associated with the coal-matrix shrinkage in a CBM Reservoir. Both are expected to occur...

04 May 2018 2,345 0 View

Is it possible to measure the average reservoir pressure using a pressure build-up (PBU) test OR static gradient surveys (SGS)?

Is it possible to measure the average reservoir pressure using a pressure build-up test (PBU) OR static gradient surveys (SGS) in a typical CBM Reservoir? What are the associated limitations?

04 May 2018 4,255 0 View

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,526 4 View

How to assess the osmotic power of a substance?

Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...

06 August 2024 977 1 View

Optimal condition for depositing FTO target 95:5% using sputter technique?

Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...

21 July 2024 1,680 2 View

What could be the possible reason that sintering of polycrystalline diamond fabricated with tape casting has suddenly started failing?

I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...

16 July 2024 3,212 5 View

The HCP removal rate is lower than usual in concentration step, why?

Hello everyone. I am working on my LV concentration porject, I use 500Kda hollowfiber to do it. The HCP and BSA removal rate is nearly 80%, but last time, I failed to run it. The HCP hasn't been...

11 July 2024 5,380 0 View

Pressure in Iron Iron Carbide?

What will be the pressure in Iron Iron-Carbide diagram? It is at atmospheric pressure?

05 July 2024 1,891 0 View

How to Perform Randall-Selitto Test (Paw Pressure Test) In Mice?

Hi All, My name is Sumaiya, a PhD student at the University of Queensland. I am looking for some suggestions on how to hold mice and perform Randall-Selitto Test by using Paw Pressure Randall...

30 June 2024 6,004 0 View

How do I dedicate my entire life in doing only one thing?

I would like to dedicate my entire life in doing only one activity alone and nothing else. How do I achieve it in this world full of unavoidable distractions and societal pressures?

24 June 2024 298 1 View

If modulus of elasticity is divided by any inertial or dynamic pressure (1/2rhov^2), is there any dimensionless number present to represent it?

While deriving for a momentum equation with elastic stress effects, I am planning to put a ratio between elastic modulus (in Pa) and dynamic pressure (in Pa) in a simplified form. I am not...

23 June 2024 8,059 1 View

Trying to find a copy of an original paper?

Despite many attempts I am still unable to find the original version of this paper and would appreciate if anyone can locate it for us: Baker PG, Haig G (1981) Metronidazole in the treatment of...

20 June 2024 5,448 3 View