Could anyone suggest me any books/tutorials to help me interpret various indices in structural equation modeling, using AMOS software?
Hi Amit.,
The below two books are the most important books in SEM using AMOS
Byrne, B. M. (2009) Structural Equation Modeling With Amos: Basic Concepts,
Applications, and Programming. Taylor & Francis Group.
Hair, J., Black, W., Babin, B., and Anderson, R. (2010). Multivariate data analysis (7th ed.): Prentice-Hall, Inc. Upper Saddle River, NJ, USA.
This book is also about multivariate statistics:
Tabachnick, B. G. & Fidell, L. S. (2007) Using Multivariate Statistics (980) Pearson.
Good luck !!
A protein dimerizes through CTD. I have expressed CTD of protein with two different tags. Now, I want to show that these CTD of protein dimerize in a pull-down assay. But my doubt is that if the...
29 January 2021 7,529 4 View
Pregabalin is a crystalline solid with a pKa1 of 4.2 and a pKa2 of 10.6. what insight can i get from this aforementioned information during drug design. What is the difference between pKa1and pKa2.
28 December 2020 7,237 3 View
If I am getting some negative values in factor loadings while performing principal component analysis (PCA), then I should use that negative values to calculate daily source contribution using...
22 December 2020 5,248 1 View
Is any article available which reports the sources of these PAHs ?
22 December 2020 8,738 1 View
We are carrying out trial in the glasshouse where we are comparing the infiltration rate in sodic soil in two different treatments Polyacrylamide vs organic matter ( lucerne pellet). within 27...
25 November 2020 8,787 3 View
Air pollution has become a very big problem in Indian cities, especially Delhi. It requires immediate attention and we need to soon understand the trends, provide forecasts for future, issue...
19 November 2020 1,433 3 View
The above question is intended to be answered in reference to the reduction of the urban heat island by the river.
22 October 2020 7,732 4 View
The flow rate of thermic fluid is less than 1 L/min and temperature ranges from 25 - 200 degree Celsius with a pressure limit of 5 bar.
06 October 2020 5,612 11 View
Hello, I need an endorsement to submit my preprints in arXiv.org. I am in the bioinformatics research field. The arXiv requires an endorsement for me because my institution doesn't provide any...
02 October 2020 1,041 4 View
How to find a relationship between velocity and weir landing length (X') as shown in figure?
28 September 2020 7,159 3 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...
03 March 2021 8,796 3 View
I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance
03 March 2021 3,568 1 View
Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...
03 March 2021 5,978 5 View
What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...
03 March 2021 1,401 3 View