How to synthesis the high temperature Alumina (Al2O3) adhesive?

27 April 2018 0 5K Report

I'm trying to synthesis the high temperature resbond, adhesive preferably Alumina adhesive (resbond).

Badges
Science topic

More Ardalan Nasiri's questions See All

How do we measure the electrical conductivity of this magnetic nanocomposite?

A magnetic nanocomposite has been synthesized and its electrical conductivity needs to be measured. What analysis and technique can be used to measure the electrical conductivity of this magnetic...

16 June 2024 7,488 3 View

What are the S-scheme and Z-scheme heterojunctions in photocatalytic systems? for the types of heterogeneous photocatalysts, how can you determine?

what are the S-scheme and Z-scheme heterojunctions in photocatalytic systems? and for the types of heterogeneous photocatalysts, how can you determine the type of S-scheme and Z-scheme?

16 May 2024 1,545 1 View

How to model a triangular load in opensees?

When modeling a concrete structure, a concrete slab has been used to cover the roof, how is the loading of this slab in the beams in opensees software؟

19 February 2024 3,267 0 View

I synthesized silver nanoparticles using the green synthesis method, but its absorption peak showed 350, hile it should be around 430 nm?

Hello every body, Can you please help me I synthesized silver nanoparticles using the green synthesis method, but its absorption peak showed 350, while it should be around 430 nm. I also observed...

26 January 2024 3,481 2 View

Hello, can you please guide me on the hydrogeling method for decellularized skin?

Hello, can you please guide us on the hydrogeling method for decellularized skin?

06 January 2024 5,332 0 View

How can i design a oligonucleotid library for morphine aptamer?

I want to design an aptamer for morphine by in sillico method and i need some basic sequence but i can not find them. if you have a library or know some article that can help me , please introduce...

27 October 2023 1,336 1 View

I made a lytic reagent for 3-part cell counter. How can I reduce the hemoglobin percentage?

All parameter is ok but hemoglobin is 4% higher than control. the formula is SDS + Triton x100+ phosphate buffer.

11 July 2023 8,274 2 View

How can I detect a specific protein single mutation using MALDI-TOF mass spectrometry?

Dear all, I am conducting research on site-directed mutagenesis of crystalline proteins. My aim is to verify the desired mutation in the protein sequence using the MALDI-TOF mass spectrometry...

07 June 2023 962 6 View

How do you find the unreported sample size from given the means and standard deviations of two study groups?

03 April 2023 6,632 6 View

Does anybody know why the transverse vortex force exerted on a SCR decreases as the suction resistance factor gets a higher value?

The transverse vortex force and in line vortex force exerted on a SCR have the maximum value near and in the TDZ when the seabed in modeled nonlinear. As the suction resistence has a higher value...

20 October 2022 8,550 0 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

AGILENT HPLC 1100 SERIES , any expert available please?

AGILENT HPLC 1100 SERIES operation assistance needed.

25 July 2024 10,045 2 View

Is it possible to do transient simulation in HFSS in presence of magnetic biasing?

I have designed magnetic material with different biasing conditions in HFSS. Now I want to give an RF AC signal and do a transient simulation in HFSS. Is it possible to do in HFSS? Please help me...

24 July 2024 9,319 5 View

Why my gel electrophoresis has smearing?

Greetings. I’m currently running a nested pcr for giardia. My mastermix comprised of 3mM Mgcl2, 5unit of taq polymerase, 0.2uM of forward and reverse primers each respectively and 0.2mM of dNtp...

22 July 2024 9,761 5 View