I want to model and the CO2 concentration in a room. I am using ANSYS fluent for this analysis. There is no equation or predetermined model available in ANSYS for this modelling. Please suggest some technique to model the above problem.
See the article below:
Article Determining the optimum spacing and arrangement for commerci...
I would like to know the what is sequential error? the causes for the same and how to avoid that? Pl provide any papers related to it.
07 August 2015 2,350 0 View
In our project we are using CNG, Hydrogen as fuel for IC engine. We need to measure the flow rate of the above. We want to do it without flow-meter/rotometer. Please, suggest methods which will...
11 December 2014 2,008 7 View
I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...
10 August 2024 3,628 1 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 940 3 View
How do interactions between the biosphere, the carbon cycle, and the water cycle impact global warming and interaction between the atmosphere and the hydrosphere?
09 August 2024 3,287 2 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,047 2 View
Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...
06 August 2024 8,714 0 View
...
31 July 2024 1,671 3 View
I am currently working on modeling FCC catalyst regeneration and have come across a point of uncertainty that I hope you can assist me with. In my previous models, I have utilized lumped kinetics...
30 July 2024 6,136 0 View
The starting material is a finely ground powder. Some particles contain more graphene than others.
30 July 2024 3,977 2 View
I am not able to find how I can provide tangential stiffness in ansys workbench The normal stiffness option is there. But how I can enter tangential stiffness I have read somewhere tangential...
29 July 2024 2,031 2 View
A computational study of heat flux on cylindrical surfaces using CNT hybrid nanofluids
28 July 2024 4,982 1 View