Hi all,

I am currently experiencing a problem with the interfacing of BIOPAC MP160 and PsychoPy. The hardware that I'm currently using is STM100C, STP100C, HLT100C, EDA100C, and STMISOLA. I do not have a Labjack U3.

We are trying to have Acqknowledge receive a trigger that is sent out by PsychoPy at the onset of a specific stimulus via parallel port to stimulate a shock using STM100C but none of the port addresses or code that we have tried worked. The script on PsychoPy would start and end without beginning the presentations but no error messages are shown.

I have tried to scour through different threads and forums on the internet but cannot find a solution. As this project is quite time sensitive, I really appreciate any help on this issue!

Best,

Michelle