Which Tablet/ notebook has 2 powerfull USB ports?

I need a tablet/portable device that can run labVIEW on it, it needs to have 2 USB powerful ports to power sensors and have enough storage(64Gb/128 Gb) and a powerful processor. Which tablet...

09 October 2017 2,478 0 View

No title

09 October 2017 6,600 5 View

Help with matlab code?

I want to have a heat map with different colors. With extreme color red and lowest blue. Something like in the picture, but with red the maximum and blue minum and other colors in between. How can...

09 October 2017 2,436 2 View

I am looking for a labVIEW program that can read data from an R&S NRP-Z81 USB power sensor or any R&S usb sensor?

I am looking for a labVIEW program that can read data from an R&S NRP-Z81 USB power sensor or any R&S usb sensor?. IS there someone who has such an program available ?

09 October 2017 6,288 0 View

I am looking for Antenna theory Analysis and Design 4th Edition?

Is there someone who has this book: Antenna theory Analysis and Design 4th Edition?

06 July 2017 2,623 0 View

Mathematical help?

I have an array of number. I am looking at the difference between each of the following number of the array. So each time a difference is found between numbers of the array that is larger than 0....

05 June 2017 5,419 2 View

I am looking for an paper with investigation of coherence times for urban and suburban areas NLOS fixed wireles TX and RX but dynamic channel ?

Is there someone who has a research paper? Preferably for frequencies around 700 Mhz, 868 Mhz, 900 Mhz

05 June 2017 1,850 4 View

Is there someone who can tell me if the RMS doppler spread formula of my is correct?

I calculated the RMS Doppler spread using Matlab but would like to know if my mathematical way of defining it is correct. In some literature, they use an integral notation, but I calculated it...

05 June 2017 9,259 0 View

How to apply autocorrelation on measured data in matlab?

I have the measured data from a vector network analyzer. I need to do a autocorrelation in time on this data. After that I need to look at the time span over which the signal level is -3dB from...

04 May 2017 9,143 5 View

Is there someone who has sone books or material about sampling a signal in time domain and frequency domain?

I am looking for sampeling theory

04 May 2017 5,006 0 View

Buffer Exchange using column packed with sephadex G-25 effect on protein concentration?

Hello, If i am doing a buffer exchange for an antibody of 1mg/mL, does the elution lose protein in the process of buffer exchange? For example, if i flow through 500 uL of 1mg/mL sample, and...

03 March 2021 6,299 3 View

No title

03 March 2021 5,360 2 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

What is the best way to calculate the angles of twist for concrete columns subjected to torsional moment using finite element software?

In Finite element software like ANSYS , there is difficulty in obtaining direct results of twisting of concrete members because SOLID65 which is the unique element designed to represent concrete...

26 February 2021 3,806 2 View

Compute for the total volume of concrete needed for the concrete pouring of the foundation including its column up to NGL only as shown in the plan?

Looking for the quantity of cement, sand, and gravel of footings and columns. Thank you!

25 February 2021 3,092 2 View

No amplification data for qPCR on MxPro?

I have set up a qPCR run on MxPro with SYBR green and ROX as a reference, however, when I go to the analysis section the program seems to only collect data for the dissociation curves and not the...

25 February 2021 8,039 1 View

Can I use TCA instead of TFA for protein analyis in RP-HPLC?

I am trying to analyze lipase using the reverse phase-HPLC C18 column. In the literature, 0.1 % TFA was and 60% ACN was used. Can I use TCA in place of TFA? If any other methods are available to...

25 February 2021 2,388 3 View

Can I use acetic acid with an ELITE WAX Perkin Elmer column for Gas Chromatography?

Hi! I would want to know if I can use acetic acid with an ELITE WAX Perkin Elmer column for Gas Chromatography. This column has a polyethylene glycol phase, but I can't find the manual to check...

22 February 2021 730 2 View

My silica gel column dried can I somehoe save the trapped matter?

I tried to separate my substance from a protein in a sillica gel column. By mistake, it dried and cracked. Can I save the trapped substance? Can I repack it ,or at least elute all of the trapped...

22 February 2021 1,789 3 View