12 December 2016 0 9K Report

I am intending to prepare 500, 1000, 1500, 2000 ppm concentrations of CdCl2, PbCl2 and CoCl2 in aqueous solutions. Please share simple methods

More Abdul Majeed's questions See All
What is the difference between Dependent and independent variables?

I intend to analyse data (Two way ANOVA) through SPSS ; however, confused in dependent and independent variables while putting data into columns of spread sheet of SPSS. My objective is to test...

03 April 2015 5,490 22 View

Has anyone Turnitin software to help me check my thesis or plagiarism?

I want to check my thesis for plagiarism by Turnitin. If anyone has Turnitin software, kindly help me in checking plagiarism for my thesis.

03 April 2014 6,329 4 View

Difference between balance incomplete block design and randomized complete block design?

Can someone help me explain what is balanced incomplete block design and in what circumstances it should be used. Does it differ from RCBD?

05 June 2013 2,694 4 View

Authors role in a manuscript

While submitting a manuscript to a journal, one of the pre-requisites for consideration (in many journals) is that "all the authors must have substantially contributed in preparing the...

04 May 2013 3,934 0 View

Difference between ANOVA and MANOVA?

In which conditions MANOVA should be used? For comparing significant differences of set of means, which statistical test LSD or Duncan Multiple Range Test should be preferred?

04 May 2013 8,899 4 View

Publishing in a journal without impact factor.

Many journals do not have any impact factor. Will publications in such journals be regarded as substandard?

04 May 2013 1,446 14 View

What is an LSD alternative for measuring significance in a multivariate analysis?

In a multivariate analysis, differences among means should be tested for significance by which statistical test? Is LSD appropriate?

04 May 2013 2,277 1 View

Which ANOVA is suitable for analysing "Variability in aggressiveness of different isolates of Phytophthora infestans"?

I am trying to find variation in aggressiveness components (infection frequency, latent period, Lesion area, Lesion growth rate and RAULEC) of ten isolates of P. infestans on detached leaf assay....

03 April 2013 1,427 20 View

What are publication ethics?

Last week I submitted a manuscript into a journal. The editorial office returned it and asked for removal of the name of one of the authors who was not from my country and institution. The...

03 April 2013 7,238 5 View

What are dependent and independent variables in a multivariate analysis?

I am trying to test aggressiveness of ten different strains of P. infestans on potato leaves. aggressiveness parameters are infection efficiency, lesion area, lesion growth rate and area under...

03 April 2013 9,813 5 View

Similar questions and discussions
MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

flexibility of polymers chain

effect of double bond on the flexibility of polymers

07 April 2021 0 0 View

Formulation of polymer color flakes

I am writing to request some information for making polymer color flakes. I would appreciate the help.

17 March 2021 0 0 View

I am interested in medicinal chemistry field, which books are highly recommended to learn from?

I am at the beginner level in drug design and drug discovery, and I am interested to learn more about this field. Which books are highly recommended to start from and gives me all essential...

02 March 2021 8,437 2 View

How Relativistic effects is one reason for lanthanide contraction?

The Lanthanide contraction which is the decrease in ionic radii of the elements in the lanthanide series from atomic number 57, lanthanum, to 71, lutetium, is due to poor shielding of the 4f...

01 March 2021 2,272 4 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close