Are there any sample preparation for specific surface area measurement?
OK, There are several experimental and theoretical methods. The best experimental and theoretical approaches are the BET analysis from Nitrogen adsorption capacity.
I wonder BET analysis can measure graphene
Is there any physical meanings for broad G*-band (2700 cm-1) peak for graphene in Raman analysis? Does anyone have experience with this analysis?
08 September 2014 1,254 29 View
Also, is there a difference between CNT, graphite and graphene based on Raman analysis? I am dealing with carbon nanomaterials.
09 October 2013 6,895 3 View
Ferrocene coated on quartz glass
08 September 2013 3,713 1 View
I want to use methane as a starting precursor for graphene growth. At the same time, waste palm oil is utilized as a starting source for the formation of methane.
08 September 2013 4,779 2 View
How to remove native oxide growth on copper or nickel foil?
03 April 2013 4,910 11 View
What is the minimum standard range of water resistivity for the semiconductor industry?
11 December 2012 4,225 2 View
Dear All, I want to quantify carbon deposition on the surface of the CuZnAl catalyst. I have tried thermogravimetric analysis, but I've got weight gain as the active Cu- get oxidised. Does anyone...
01 March 2021 1,907 3 View
I am a student of MS Environmental Engineering and started my research phase. I am working on metal removal ( chromium iii ) by using activated carbon prepared from the agricultural feedstock. So...
01 March 2021 5,475 2 View
In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...
01 March 2021 2,207 3 View
Nanotechnology in concrete materials
01 March 2021 3,379 3 View
I'm Juan Carlos, a high school student who is working with electropinning, I made an electropinning machine with a 21g needle and a 30kv high voltage source and the distance between my needle is...
28 February 2021 298 3 View
When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...
28 February 2021 2,133 3 View
I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...
28 February 2021 4,890 3 View
Dear all, I am trying to perform a MD simulation about the interaction between CO2 and a polymer. I create my model, solvate it and perform the NVT and NPT equilibration. Now I am not able to...
26 February 2021 10,014 3 View
I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...
26 February 2021 8,183 3 View
Has anyone ever tried to deliver CO2 with a CGA 300 regulator? I know that a CGA 320 regulator is standard for CO2. The issue is that I currently do not have any free CGA 320 regulators. I also...
25 February 2021 3,292 3 View