Dear Sir. Concerning your issue about the identification of tomentosin and inuviscolide in a mix of plant extract . Plant extracts were obtained from air dried D. viscosa young shoots (DvA) and F. communis aerial part (FcA) and roots (FcR) with n-hexane. The chemical compositions of the extracts were analyzed by HPLC-DAD, LC-MS (ESI) and LC-Q-TOF techniques. Two sesquiterpene lactones (inuviscolide, tomentosin) and three sesquiterpene acids (costic acid, hydroxycostic acid, ilicic acid) were identified from the D. viscosa extract, while in F. communis extracts three daucane sesquiterpenes (acetoxyferutinin, oxojaeskeanadioyl anisate, fertidin) and one coumarin (ferulenol) derivates were found. Biological activities of plant extracts were studied in in vitro experiments on the colonies and conidia of Botryotinia fuckeliana, Penicillium digitatum, P. expansum, Monilinia laxa, M. fructigena and Aspergillus spp. Extracts showed varying degree of antifungal activities on colony growth and conidia germination. The extract from FcA showed the least effect, while DvA extract had the strongest fungitoxic effects. FcR extract presented a fungitoxic effect on the colony growth, but it was not able to inhibit the conidia germination. These distinctions can be attributed to the differences in chemical composition of plant extracts. I think the following below link may help you in your analysis:
If you characterize the n-hexane extracts of your plant by HPLC-DAD, LC-MS (ESI) and LC-Q-TOF analyses, you should be able to identify your phytochemicals of interest using their profiles at different wavelengths. See the attached document.