we all know that the report will give us the same number of capacitance of resistance that found in the circuit, however, how to know that the first capacitance in the report is for CPEdl ( as example).
03 March 2021 8,272 1 View
My study consists simple corrosion inhibitors in salty brine. Right now I just fit my circuit with randles with CPE. Just wondering how the slop can given more info of the experiment. Or any...
01 March 2021 6,474 3 View
Hello, I would like to ask how to grow E.coli which resists 50 or 100ug/ml of Blasticidin. I have tried many methods by using low salt Luria-Bertain(LB) agar plate. However, no colonies grow. Let...
01 March 2021 2,027 2 View
Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...
28 February 2021 2,116 1 View
Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...
28 February 2021 7,016 1 View
I have a doubt on how to select the inductor and capacitor value when I want to implement MPPT controller. This is because we always take a maximum output voltage and current but in this case, we...
28 February 2021 3,637 2 View
I want to measure change of capacitance due to relative displacement between two parallel plates in COMSOL. Distance between two plates changes with time. So I'm using a time dependent study but...
26 February 2021 8,567 3 View
Hi, I'm looking for a pen/marker to write on the smooth, transparent (non-frosted) part of microscopy slides which does not get washed away by alcohols and most importantly Roti-Histol. I want to...
24 February 2021 9,902 5 View
Hi everyone, I need to expression of GFP with pET28 plasmid in E. coli BL21(DE3) plysE. Transformed cells have kanamycin and chloramphenicol resistance. Normally, only transformed cells should...
22 February 2021 4,032 4 View
What are the testing rate for electrodes recommended by ASTM for cochlear implants. I am currently doing the 15mm/min elongatio testing.
22 February 2021 1,515 1 View