How to get Openstuidio Summary Results (including graphs) in SI units?

01 January 1970 0 4K Report

In Openstudio "Results Summary", I have chosen the Metric units from preferences but the results still appear in IP units.

Is there a way to see all the results and graphs in SI units.

Badges
Science topic

Similar topics
Mathematical Sciences
Graphs

More Samah K Alghoul's questions See All

How to model a refrigerator in OpenStudio?

I am working on residential building and when I tried to model a kitchen refrigerator I got a very high load for the refrigeration system, about 60% of the annual energy consumption. My...

04 May 2018 8,012 4 View

Is there a way to compare the results obtained from Parametric Analysis Tool (OpenStudio)?

I am trying to get results of different alternatives in one screen/sheet but can not find a way. I suppose that there is a measure may do this job.

01 February 2016 2,214 1 View

What is the best free CFD Modeling software that can be used for a first CFD course in Mechanical Engineering?

In my school we teach CFD in Master level in which students write their own code by using either Fortran or Matlab. We would like to introduce CFD software for mini course projects.

08 September 2015 3,443 4 View

What is the difference between energy management opportunities (EMO's) and energy conservation measures (ECM's)?

Dear colleagues, Is there any difference between those expressions? I notice that researchers use them for the same reasons which is energy saving. Please advise.

01 January 1970 2,123 4 View

How to develop investments in renewable energy sources?

08 August 2024 5,112 3 View

Aspen Plus Simulation?

Greetings When one is to perform Simulation or modelling of Pyrolysis of Biomass Waste materials using Aspen Plus software, and one has both the macromolecules breakdown (Cellulose, Lignin and...

06 August 2024 5,023 1 View

How can I add own Henry coefficients in Aspen Plus?

Hi, i would like to simulate an absorption process in Aspen Plus. I want to use the NRTL model und would like to add some individual Henry coefficients. Is that possible and how?

05 August 2024 2,333 2 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

How to increase protein lysate concentration?

I am trying to prepare samples for IP. The pellet size is good and I am using 1% Tx-100 and using a syringe to further lyse the cells and maintain protein-protein interactions. I keep having a...

01 August 2024 7,199 1 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Is there a database with onshore wind production for the wind farms in Portugal?

I am looking to predict some production for future onshore wind energy production in Portugal, is there any database with info of performances of the existing wind farms in the country? something...

28 July 2024 1,750 1 View