How to find the sintering parameters using Thermo Mechanical Analyser(TMA) for copper?

More Vignesh Babu R's questions See All

What is the exact usage of Epoxy/Copper based composites? where can I see the examples.?

general examples like packaging, sensors etcs., are known things. Exact point of usage

06 July 2018 1,088 0 View

What could be the maximum pressure applied on the pure Copper for compaction?

For consolidation purpose and what happens if if go beyond 500MPa pressure

01 February 2018 9,854 0 View

What is the production process of CaFe ferroalloys?

I looking for ferro calcium production process

03 March 2021 1,755 4 View

12% ledeburitic cold work tool steel, etched for revealing retained austenite, any help for clarifying?

Hello everyone. Given microstructure image belongs to a 12% ledeburitic cold work tool steel (annealed and tempered). The sample was etched with picral (100 mL ethanol and 4 g picric acid). I...

02 March 2021 4,119 3 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

For Carbon-emission free steelmaking by electrolysis with nonoxidizable electrode in EAF, what would be electrode material?

While CCS can be employed along with a conventional Carbon-efficient EAF steelmaking process (especially from iron ore) or even Hydrogen or hydrocarbon can bee passed through central electrode,...

30 January 2021 3,378 1 View

What are the thermodynamic and kinetic similarities and differences among dendrite formation during solidification of metals, ceramics and polymers?

Basic dendrite formation of metallic alloys are explained by thermal and constitutional degree of supercooling and most-supercooled band of liquid somewhat ahead of solidification front that...

30 January 2021 8,450 2 View

Control in microstructure with growth inhibitor?

Dear researchers, I wish to understand the role of grain growth inhibitor in controlling the microstructure of the ceramic pellet. How it controls the growth? Also, I wish to know the grain...

15 January 2021 3,859 3 View

How much Ti and B (in ppm) is required for effective grain refinement and why?

To have the desired grain size in 6061 and 6063 Al alloy, what should be the minimum % of Ti and B pick up and what is the chemistry/metallurgy behind that?

07 January 2021 9,305 2 View

Which analysis method in XRD analysis is the most accurate way to measure crystallite size & lattice starin? Scherrer, Williamson-Hall or Rietveld?

Here are three different ways to calculate crystallite size and lattice strain of a sample, based on XRD peaks: "Scherrer" calculation, "Williamson-Hall" or "Rietveld". Each calculation is proper...

04 January 2021 7,836 4 View

How are nickel based super alloyed turbine discs produced with powder metallurgy?

I am researching this subject for my Powder Metallurgy class. I couldn't find a solid information on production steps.

29 December 2020 5,503 3 View

Hello everyone, which software is preferable for simulating the effect of shrinkage of metal powders for the Additive manufacturing process?

Last time I was asked about simulation software to analyze the effect of shrinkages of plastic powder materials. Currently, an additive manufacturing process is what I find suitable for my...

29 December 2020 4,615 9 View